2.2kw Single or Three phase Meat Cutting Bandsaw
Operation and Installation Guide
WARNING
Please make sure you read the manual and operate the machine according to this document. The
user should understand everything before operating the machine.
The machine can cause serious harm to users if the user does not operate safely and in accordance
to the manual.
Installation.
The machine is well packaged, please make sure you are assembling or disassembling the machine
on level, flat ground.
The end location of the machine should be put on a steady and even ground, there is slight
adjustment in the feet should it be required.
Please check the power requirements of the machine and ensure you have adequate power supply
for either the single phase or three phase machine.
Ensure the blade is well tensioned by adjusting the tension knob. It must be parallel with the edge
on the wheel. Ensure the blade guides are in the correct location.
Close the machine door, connect/switch on the power. Test the machine before proceeding with
cutting.
NOTE:
The machine should be running in a clockwise direction.
Install the machine in a location that is not busy.
If the saw blade is not correctly tensioned, please raise or lower the top wheel to suit.
Always operate with a sharp, undamaged blade.
Operation Instructions:
When you are operating the machine, please take the meat with the push-blade handle with your
right hand and place meat in front of blade.
Hold the push-blade handle with left hand. Use your right hand on the sliding table to push the meat
through the saw.
Never put your hand or any parts of your body near the meat blade.
Before continuing to cut other parts ensure the table is clear from any debris or obstruction. Do not
attempt to remove any obstructions unless the machine is powered off.
NOTE:
Use all appropriate personal protection equipment (such as gloves and eyewear) when using
the saw.
Always be aware of your surroundings while operating
Replacing the saw blade
Ensure machine is off and no power can get to it before attempting to change the blade.
When replacing the saw blade, open the door, loosen the tension by turning the top knob
anticlockwise.
Remove the blade paying close attention to how it is installed.
Install the new blade, for the correct TPI we recommend contacting your local saw agent to get
recommendations for what blade to use.
Re-tension the blade and ensure the guides are in the correct position
Ensure you are always using a sharp, undamaged blade.
Cleaning
Ensure machine is off and no power can get to it before attempting to clean.
Open the door, loosen the tension off the blade. Remove the blade.
Clean the blade using a hot damp cloth, ensure to be careful not to damage the teeth.
Identify, wipe and remove all debris, liquid etc from the machine.
DO NOT HOSE DOWN
The whole machine should be cleaned with hot soapy water on a cloth, the machine is not
waterproof so ensure you remove any and all excess water or fluids when cleaning to avoid
damaging the machine.
Maintenance.
Regulary check the blade for any damage/sharpness. Replace if necessary.
After 200 hours of operation we advise the machine will need lubrication to increase life
expectancy.
After 2500 hours bearings may need to be replaced.
Model: HLS-2020
Material: Aluminium and Magnesium.
Power:2200w
Blade Length: 2400mm
Power type: Single or Three Phase
Work table size: 560x655mm
-
1
-
2
-
3
-
4
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Grizzly T32304 Owner's manual
-
-
-
-
-
Craftex CX Series CX123 Owner's manual
-
-
Woodstock W1849 Owner's manual
-
Shop fox W1849 Owner's manual
-