IKEA BLÅSER Self-adhesive mirror Operating instructions

Home » Ikea » IKEA Blaser Self-Adhesive Mirror Instructions

BLÅSER

Contents

1 Blaser Self-Adhesive

Mirror

2 Documents / Resources

3 Related Posts

Blaser Self-Adhesive Mirror

Self-adhesive mirror

Note: The surface can be damaged when removing the mirror from the wall.

The mirror ﬁx to most surfaces which are even.

Fixing mirror to ceilings and sloping ceilings is not recommended.

The mirror can be used in bathrooms, but should not be ﬁxed where they come into direct contact with water,

since water may damage the adhesive. On porous surfaces like plywood and ﬁbreboard, adhesion can be

improved if the surface is ﬁrst coated with high-gloss lacquer.

Wipe the wall surface so that it is clean and dry before ﬁxing the mirror.

Wipe the back of the mirror so that it is clean and dry before sticking the tape on it.

Position and ﬁx the tape according to the illustration in the assembly instruction.

Remember to position and ﬁx the mirror correctly from the start since the tape cannot be reused.

The mirror may break when removing it from the wall. Be careful.

IKEA Blaser Self-Adhesive Mirror Instructions

Manuals+ — User Manuals Simpliﬁed.

Documents / Resources

IKEA Blaser Self-Adhesive Mirror [pdf] Instructions

Blaser Self-Adhesive Mirror, Self-Adhesive Mirror, Blaser Mirror, Self-Adhesive, Mirror

Manuals+,