Brodit 215506 Datasheet

Category
Holders
Type
Datasheet

This manual is also suitable for

6 December, 2011, www.brodit.com, © 2011 Brodit AB
Product 215506
215506 MultiStand Mounting Adapter and Screws Included. Black.
A versatile multi stand which is perfect for you who use your Galaxy Tab in several places. You easily place the
Galaxy Tab in the stand, it is then firmly attached wherever you go! Convenient to use anywhere at home, in the
car or in the office.
When using the multi stand it is easier to carry your Galaxy Tab around with you. It diminishes the risk to drop it,
since the stand is easier to grip than the device itself. You can use the stand in several angles, just adjust the
position depending on area of use. Also adapted for use in the lap. Made of black ABS plastic.
You can connect e.g. a charging cable to the Galaxy Tab when it is in place in the stand, all buttons and
connectors are easy accessable. You can easily switch between landscape and portrait mode.
You can attach the stand onto a wall, or any other place, by using the enclosed mounting adapter. If you want to
be able to attach the stand onto more than one place, you can buy several mounting adapters (see item no
215461).
Tablets should not be installed onto a car's dashboard if blocking the view or key controls. ProClip is designed for
use with smaller devices like smartphones. If you want to place a tablet onto a dashboard, each combination of
tablet-car must be examined in detail by yourself in order to determine if such an installation is possible in the
specific case. Brodit will not give any recommendations for such installations. An installation of a tablet onto a
vehicle's dashboard is always done on the customer's own responsibility.
EAN: 7320282155063
Item no 215506 fits:
Samsung Galaxy Tab 8,9 GT-P7300
1(2)
1. 2.
INSTALLATION INSTRUCTIONS
4.3.
Please read all of the instructions and look at the pictures before attaching the holder.
1. The multi stand. To install the multi stand: Press the mounting adapter on the back side of the holder
downward, so it slides out from the groove.
2. Place the mounting adapter into desired position and screw it into place with the enclosed screws. Place the
holder above the mounting adapter and press it downward so the mounting adapter fits into the groove. Press
until you hear/feel it snaps into place. To remove the holder: Pull the holder straight upward, away from the
mounting adapter.
3. To place the unit in the holder: Place the lower part of the unit in the holder, then flip/press the upper part
forward so it snaps into place in the holder. To remove the unit from the holder: Press upwards on the upper part
of the holder, in the same time pull the upper part of the unit out from the holder and then lift it up and out from
the holder.
4. The holder is in place in upright, horizontal position.
2(2)
  • Page 1 1
  • Page 2 2

Brodit 215506 Datasheet

Category
Holders
Type
Datasheet
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI