Ampire EK-KC203-BLK-2G Owner's manual

Type
Owner's manual
ampire
KC203-SIL
KC203-BLK
German Engineering. Out of the ordinary.
Owner’s Manual
English
Before attempting to connect or operate this product, please read the instructions completely.
Connection
2
3
Precautions
• Pay utmost attention if you install the camera into the driver’s compartment.
• Use only in right vehicles.
• Make the correct connections.
• Do not damage pipe or wiring when drilling holes.
• Arrange the wiring so it is not crimped or pinched by a sharp metal edge.
• Do not install the camers in locations which might hinder vehicle operations and
do not install in locations with any moisture. Use the installation materials
provided with the camera.
• Warning! Wrong installation may damage the vehicles electronic! Pay utmost
attention on instructions of the vehicles manufacturer. This camera is developed
for motor vehicle use only.
Environmental Reference
• Old electronic devices don’t belong into the bin.
• If you want to dispose this equipment later, remove all cables
and send it back to Ampire or bring it to a collection point for
old electronic devices.
• You can dispose this device together with your old car, too.
You don’t have to remove it in this case.
• The packing can be recycled. Dispose the packing in a
collecting system planned for it.
EN
Electronics Subject to correction and technical modifications
ampire
2016
Install the KC203-NTSC-xxx onto the right
place and drill a hole of 5,5mm for the
wire harness.
Put the cable though the hole and install
the grommet to protect the wire and
avoid flooding.
Run the cable and connect it according to
the description above.
Attention, isolate the cut wires to avoid
short circuits!
1
Black
(-) Ground
2
Red
(+) 12V (reversing lamp wire)
3
RCA Yellow
Video Output
4
Loop
Connect for non mirror image
Schlaufe
EN
Electronics Subject to correction and technical modifications
ampire
2016
Connection
2
3
Precautions
Warranty
• Pay utmost attention if you install the camera into the driver’s compartment.
• Use only in right vehicles.
• Make the correct connections.
• Do not damage pipe or wiring when drilling holes.
• Arrange the wiring so it is not crimped or pinched by a sharp metal edge.
• Do not install the camers in locations which might hinder vehicle operations and
do not install in locations with any moisture. Use the installation materials
provided with the camera.
• Warning! Wrong installation may damage the vehicles electronic! Pay utmost
attention on instructions of the vehicles manufacturer. This camera is developed
for motor vehicle use only.
12 month warranty for commercial use and 24 month warranty for private use only.
The location of buying (point of purchase) must be within the EU. The proof of
warranty is the original cashiers receipt with date and type of item on it. The
owners manual and installation instructions must be observed. No warranty of
destruction by wrong installation, wrong operation, non regulated use, using of
unsuitable accessories, electrical shocks, fire, moisture or smoke, damage by
improper service and cleaning. Warranty repairs are free of charge. No refund of
shipping costs or labour as well as subsequent damages. Complaints and repairs
do not extend the warranty period.
Environmental Reference
• Old electronic devices don’t belong into the bin.
• If you want to dispose this equipment later, remove all cables
and send it back to Ampire or bring it to a collection point for
old electronic devices.
• You can dispose this device together with your old car, too.
You don’t have to remove it in this case.
• The packing can be recycled. Dispose the packing in a
collecting system planned for it.
EN
Electronics Subject to correction and technical modifications
ampire
2016
Install the KC203-NTSC-xxx onto the right
place and drill a hole of 5,5mm for the
wire harness.
Put the cable though the hole and install
the grommet to protect the wire and
avoid flooding.
Run the cable and connect it according to
the description above.
Attention, isolate the cut wires to avoid
short circuits!
1
Black
(-) Ground
2
Red
(+) 12V (reversing lamp wire)
3
RCA Yellow
Video Output
4
Loop
Connect for non mirror image
Schlaufe
EN
Electronics Subject to correction and technical modifications
ampire
2016
Technical Data
4
EN
Electronics Subject to correction and technical modifications
ampire
2016
Image Sensor
Sharp 1/4” Color
Effective Pixels
512 x 492
Resolution
420 TV Lines
S/N Ratio
>48 dB (AOC on)
Minimum Illumination
0 Lux (Infrared)
Diagonal Angle
120°
Protection Category
IP66
Video Output
1,0 Vp-p, 75 Ohms
Dynamic Range
>70 dB
Power
DC 12 V
Power Consumption
146 mA max.
Working Environment (Relative Humidity)
-30° ~ +70° C (Rh 95 %)
Dimensions (LxHxW)
50 x 50 x 60 mm
ampire
KC203-BLK KC203-SIL
Since its founding in 1987 Ampire Electronics has only one goal, to provide the best possible
Autoalarm-, Autohifi- and Multimedia products, which are available on the international market.
All manufacturing facilities and suppliers are certified according to ISO 9001 and QS-9000.
Ampire quality products are sold worldwide.
An Ampire customer service is available in many countries.
For more information about distributors in your territory please call: + 49-2181-81955-0.
We are focused on future oriented development of user friendly products.
The outstanding high quality standards, functionalities and designs of our products are
unique in the market. "German Development" is taken literally in AMPIRE.
© 2016 AMPIRE ELECTRONICS. All rights reserved. Reproduction in whole or in part without written permission.
Langwadener Straße 60
D-41516 Grevenbroich
Support
+49 2181-81955-0
www.ampire.de
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5

Ampire EK-KC203-BLK-2G Owner's manual

Type
Owner's manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI