Encore electronic ENDSL-A2+WIG User manual

Encore electronic
Brand
Encore electronic
Model
ENDSL-A2+WIG
Category
Networking
Type
User manual
ENDSL-A2+WIG
ADSL2+ Modem with Wireless Router
ENDSL-A2+WIG full rate ADSL2+ router is an all-in-one ADSL2+ router for
Home and SOHO applications. This gateway are with full-featured ADSL router
that provides high-speed Internet access, 4-port Ethernet switch direct
connections to individual PCs or local area network with 10/100 Base-T Ethernet
and a 54Mbps IEEE802.11g wireless connectivity.
ENDSL-A2+WIG uses advanced ADSL chipset solution with complete set of
industry standard features for high-speed Internet access. Also built-in 54Mbps
IEEE802.11g wireless service can provide you easy and convenient way to
connect the PCs and Internet. User can enjoy higher quality multimedia and real-
time applications such as online gaming, Video-on-Demand, VoIP and other
bandwidth consuming services. Also the feature-rich routing functions are
seamlessly integrated to ADSL service for existing corporate or home users.
The switch is plug-n-play without any software to configure and also fully
compliant with all kinds of network protocols. Moreover, the rich diagnostic LED’s
on the front-panel can provide the operating status of individual port and whole
system.
Features:
• Full rate operation with up to 24Mbps downstream data rate and up to
1Mbps upstream data rate enables High-speed Internet access
• Compliant with IEEE802.11g standard and with data transfer rate up to
54Mbps
• Friendly GUI Configuration and Management
• Ongoing feature enhancements through FTP / TFTP download or upload
of new firmware and configuration files
• Universal Plug and Play (UPnP) support
• Provide ALG to support many major applications, such as MSN
Messenger, AIM (AOL Instant Messenger), CuseeMe, ICQ, IRC, LDAP,
PPTP, FTP, Quake, RTSP (RealTime Streaming Protocol), SIP, H.323…
• Enables end-to-end ATM support, which allows traffic management and
QoS.
• Built-in DHCP server automatically assigns IP addresses to all
workstations on your LAN.
All management and monitoring can be done through Telnet session.
Specifications:
ADSL Compliant:
‧ ANSI T1.413 issue 2
‧ ITU-T G.992.1 (G.dmt)
‧ ITU-T G.992.2 (G.lite)
‧ G.994.1 (G.hs, Multimode)
‧ ITU-T G.992.3 (ADSL2 G.dmt.bis)
‧ ITU-T G.992.4 (ADSL2 G.lite.bis)
‧ ITU-T G.992.5 (ADSL2+; Annex A, B, I, J, L & M)
‧ Reach Extended ADSL (RE ADSL)
ATM and PPP Protocols:
‧ Support up to 8PVCs
‧ ATM Forum UNI 3.1/4.0 PVC
‧ Multi Protocol over AAL5 (RFC1483 / 2684)
‧ VC and LLC Multiplexing
‧ PPP over Ethernet (RFC 2516)
‧ PPP over ATM (RFC 2364)
‧ Traffic Shaping (ATM QoS) UBR, CBR, VBR, VBR-rt, VBR-nrt
‧ OAM F4 and F5 segment end-to-end loop-back, AIS, and RDI OAM cells
‧ VPI is 0-255 and VCI is 32-65535
Bridging and Routing:
‧ Ethernet to ADSL self-learning Transparent Bridging (IEEE 802.1d)
‧ IP routing-RIPv2 (backward compatible with RIPv1)
‧ Static IP routing
‧ Routing (TCP/IP/UDP/ARP/ICMP)
‧ IP Multicast IGMP v1/v2
IP Management
‧ NAT (Network Address Translation)
‧ NAPT (Network Address and Port Translation)
‧ DHCP Server / Relay / Client (WAN Port)
‧ DNS Proxy
‧ Dynamic DNS,
‧ UPnP support, Virtual Server and DMZ host
WLAN Network
‧ Compatible with IEEE 802.11b/g
‧ 64/128 bits WEP Encryption
‧ WPA-PSK, TKIP / WPA2-AES, PSK
‧ Supports Quality of Service (QoS), 802.11e, WMM
‧ MAC Address Filtering
Security
‧ PPP over PAP (Password Authentication Protocol; RFC1334)
‧ PPP over CHAP (Challenge Authentication Protocol; RFC1994)
‧ DoS Protection
‧ Stateful Packet Inspection (SPI)
‧ VPN (IPSec, PPTP, L2TP) Pass-Through
‧ Built-in NAT Firewall
‧ IP-based Packet filtering
‧ Password Protected System Management
Web Based Management
‧ Web-based GUI Configuration / Management
‧ Command-line Interpreter (CLI)
‧ Telnet Remote Management
‧ Firmware upgrade via FTP / TFTP
‧ Support SNMP V.1 and V.2C
‧ Built-in Diagnostic tool and IP Ping
Interface
‧ Four RJ45 ports compatible with IEEE 802.3/802.3u, 10/100Mbps auto
selection
‧ One RJ11 port for ADSL connection
‧ One power switch button
‧ One reset button for restoration of factory default setting
LED Indicators
‧ Power, LAN, ADSL, LANx4
Antenna
‧ One external antenna
Wireless Frequency
‧ 2.400~2.4835 Ghz
Receiver Security
‧ IEEE 802.11b: -84 dBm (typical), IEEE 802.11g: -60 dBm (Typical)
Transmit Output Power
‧ 11b : 19±1 dBm, 11g : 15±1 dBm
Power Adapter
‧ 12VAC, 1A
Dimensions (app)
160 mm (Length) x 130 mm (Width) x 24 mm (Height)
Net Weight (app)
‧ 320g
Operating Temperature
‧ 0°C ~ 45°C
Humidity
‧ 5% ~ 95% (Non condensing)
Storage Temperature
‧ -20°C ~ 70°C
Support Operating System
‧ Windows® 998SE, ME, 2000, XP, Windows Vista™, MAC OS X
Regulations
‧ FCC Part 15, CE
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Encore electronic ENDSL-A2+WIG User manual

Encore electronic
Brand
Encore electronic
Model
ENDSL-A2+WIG
Category
Networking
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents