SonicWALL NSA 240 Installation guide

Network Security

USB Bracket Assembly for SonicWALL TZ 210 / NSA 240

USB Bracket Assembly for SonicWALL TZ 210 / NSA 240 – Installation Guide

Installation Guide

Step 1 – Fasten Bracket

1. Fix the USB bracket over the front panel of the NSA 240 appliance.

2. On the bottom of the appliance, use the torx wrench and screws to mount the bracket.

Step 2 – Loosen Security Screws

3. Using the torx wrench, loosen the screws on the top of the bracket.

4. Insert the USB device.

USB Bracket Assembly for SonicWALL TZ 210 / NSA 240 – Installation Guide

Installation Guide

Step 3 – Secure USB Device

5. Tighten the screws with the torx wrench until firm.

6. Verify that the USB device is securely in place and cannot be removed.

NOTE: The minimum and maximum opening sizes for a USB device are 6mm and 12.5mm, respectively.

______________________

Last updated: 9/7/2009

Prepared by: PLydon

This manual is also suitable for

Download PDF