2. Powerfist
  3. 9109604

Powerfist 9109604 Owner's manual

  • Hello! I'm a chat assistant, and I've reviewed the user manual for the POWERFIST 4WD Gas-Powered Wheelbarrow. This manual includes important safety instructions, and specific procedures for starting, operating, and maintaining the wheelbarrow. I'm ready to answer any questions you might have about the device or the contents of this document.
  • What should I do before fueling the wheelbarrow?
    What should I do before cleaning, repairing, or inspecting the wheelbarrow?
    What type of oil should I use to lubricate the wheelbarrow?
SPECIFICATIONS
HAZARD DEFINITIONS
INTRODUCTION
SAFETY
WARNING! Read and understand all instructions before
using this tool. The operator must follow basic
precautions to reduce the risk of personal injury
and/or damage to the equipment.
WORK AREA
PERSONAL SAFETY
WARNING! Wear personal protective equipment
approved by the Canadian Standards Association (CSA)
or American National Standards Institute (ANSI).
PERSONAL PROTECTIVE EQUIPMENT
PERSONAL PRECAUTIONS
SPECIFIC SAFETY PRECAUTIONS
WARNING! DO NOT let comfort or familiarity with
product (gained from repeated use) replace strict
adherence to the tool safety rules. If you use this tool
unsafely or incorrectly, you can suffer serious personal
injury.
FUEL SAFETY
Warning! Always shut the engine off and allow to cool
before fuelling. Never add fuel to a machine with a
running or hot engine. Move at least 10 ft. from the
refuelling site before starting the engine to avoid an
explosion or fire.
UNPACKING
WARNING! Do not operate the tool if any part is
missing. Replace the missing part before operating.
Failure to do so could result in a malfunction and
personal injury.
IDENTIFICATION KEY
ASSEMBLY &
INSTALLATION
OPERATION
COLD STARTS
WARM STARTS
USING THE WHEELBARROW
STOPPING THE ENGINE
CARE & MAINTENANCE
WARNING! Before cleaning, repairing, inspecting or
adjusting this tool, make sure the engine is off and
that all parts have stopped moving. Disconnect the
spark plug wire and keep away to prevent accidental
starting.
WARNING! Always position the tool in such a way that
it cannot shift, move or roll during inspection or
maintenance.
WARNING! Only qualified service personnel should
repair the tool. An improperly repaired tool may
present a hazard to the user and/or others.
OIL
CLEANING
LUBRICATION
NOTICE! NEVER use a penetrating oil to lubricate the
tool. Penetrating oil may act as a solvent that can
break down the grease and cause the tool to seize up.
DISPOSAL
IMPORTANT! DO NOT pollute the environment by
allowing uncontrolled discharge of waste oil.
STORAGE
TROUBLESHOOTING
Problem(s)
Possible Cause(s)
Suggested
Solution(s)
PARTS BREAKDOWN
PARTS LIST
NO
DESCRIPTION
PARTS BREAKDOWN - GEARBOX
PARTS LIST - GEARBOX
NO
DESCRIPTION
/