Kilpatrick Audio K6101 User manual

  • Hello! I'm your chat assistant. I've reviewed the user manual for the Kilpatrick Audio K6101 Dual Envelope module. This document describes its features, including dual channels, oscillator and envelope modes, adjustable up and down times, and the various modes for its third knob and outputs. I'm ready to answer any questions you have about using this module.
  • What voltage does the K6101 Dual Envelope require?
    What are the output voltage ranges?
    What modes can the third knob be set to?
    What are the envelope modes?
    What output modes are available?
K6101DualEnevelope
UserManual
DownloadaPDFversionofthemanualhere:K6101-dual_envelope-manual.pdf
NotethatPDFmanualsareautomaticallygeneratedfromwebpages.Linksandembeddedmediawillnotbeaccessible.Forthefullexperiencevisit
ourwebsite:www.kilpatrickaudio.com
Introduction
TheK6101DualEnvelopemodulefromKilpatrickAudioisaEurorackversionofthefamousPHENOLenvelopegenerator.Thiswascreatedby
populardemandandwilldefinitelyaddanewlevelofcreativitytoyourmodularsystem.
Setup
TheK6101DualEnveloperequiresonly+12Vand-12V.Makesureyouuseagoodpowersupplythatisnotoverloaded.Thevoltagesshould
measureascloseto+12Vand-12Vaspossible.
Togetsomethinghappeningrightaway,turnthethirdknobonthetoprowallthewayup.Turnthelefttwoknobsuphalfway.Setthetopgroupof
blackbuttonssothatonlythetoponeison.Thisputsthefirstchannelintooscillatormode.PatchtheOUT1jacktothepitchinputonanoscillator.
Tryturningdownthethirdknobtoquantizetheoutput!
JacksandControls
TheK6101isadualchannelunit.Otherthansharingsomecircuitryandapanel,thetwochannelsfunctioncompletelyindepedentlyofeachother.
Notethatbuttonsareusedtochangemodes.Thesesettingsareautomaticallystoredinnon-volatilememoryandshouldrestoretheprevious
settingwhenpowerisapplied.
Thefunctionofeachofthejacksisasfollows:
GATEIN1/2-Triggertheenvelope-inoscillatormodethisinputcanbeusedtomomentarilytriggertheoscillator
CVIN1/2-Adjusttheenvelopetimeoroscillatorspeed-thissignalwilladdorsubtractfromthecurrentpanelssettings
OUT1/2-Theenvelopeoroscillatorsignaloutput-theoutputvoltagecanrangefrom-5Vto+5V-anLEDabovetheGATEbuttonshows
theoutputlevelasred,(negativevoltage)green(positivevoltage)oroff(nearzerovolts)
Controls
Thefunctionofeachcontrolisasfollows:
UPTIME/SPEEDKNOB-Setstheuptime(envelopemodes)oroscillatorspeed(oscillatormode)
DOWNTIME/LEVELKNOB-Setsthedowntime(envelopemodes)oroutputlevel(oscillatormode)
THIRDKNOB-Hasthreepossiblemodeswhicharesetwiththethirdknobmodebutton(describedbelow)
GATE-Buttontomanuallygenerateagatesignal-alsohasanLEDthatshowswhenthegateison
Envelope/OscilltorModeButton-Topbuttonselectsbetweenthemainoscillator/envelopemodesasdescribedbelow
ThirdKnobModeButton-Middlebuttonselectsbetweenoneofthreemodesforthethirdknob
OutputModeButton-Bottombuttonselectsbetweenoneofthreeoutputmodes
Oscillator/EnvelopeModes
YoucanoperatetheK6101channelsintwodifferentenvelopemodesoranoscillatormode.Themodesaredescribedbelow:
OscillatorMode
TopmodeLEDwillbeoninthismode.Inoscillatormodetheoutputgeneratesatrianglewave.Thespeedisvariableusingthefirstknob,andthe
outputlevelisvariedwiththesecondknob.Whenyouturnonoscillatormode,thegatewillbelatchedonautomatically.Bypressingthegate
buttonorinputtingagatesignal,youcanoperatetheoscillatorinmomentarymode.Toresetthelatch,turnoscillatormodeoffandbackonagain.
Attack-ReleaseMode
TopmodeLEDwillbeblinkinginthismode.Inattack-releasemode,theoutputwillrampupatatimesetbythefirstknob(UPTIME)andfadeback
downautomaticallyatatimesetbythesecondknob.(DOWNTIME)Thelengthofthegatehasnoeffectontheenvelopeoutput.
Attack-Hold-ReleaseMode
TopmodeLEDwillbeoffinthismode.Inattack-hold-releasemode,theoutputwillrampupatatimesetbythefirstknob(UPTIME)andstayatthe
maximumvalueaslongasthegatesignalispresent.Whenthegateisreleasedtheoutputwillrampdownwithatimesetbythesecondknob.
(DOWNTIME)
ThirdKnobModes
Thethirdknobcanbeassignedtoaffectthreedifferentparameters.Themiddlemodebuttonselectsthemode.Thesearedescribedbelow:
GateDelayMode
MiddlemodeLEDwillbeoninthismode.Thethirdknobwilladjustthegatedelay.Whenagatesignalisinputorthegatebuttonispressed,a
timeoutmustoccurbeforethegatewilltrigger.Turnthethirdknobtoadjustthedelay.Thedelayonlyaffectsthegateturningon.Whenthegateis
removedtheoutputwillchangeimmediately.
ScalesMode
MiddlemodeLEDwillblinkinginthismode.Thethirdknobwilladjustwhichoneof16pre-programmedscalesandarpeggiosareusedtoquantize
theoutput.Theoutputiscalibratedbydesignbutmightnotbeexactly1V/octave.
StepsMode
MiddlemodeLEDwillbeoffinthismode.Thethirdknobwilladjusttheamountofquantizationorthenumberofstepsintheoutput.Therange
goesfrom2steps(minimumsetting)tofullysmooth.(maximumsetting)
OutputModes
Theoutputcanbepresentedinthreedifferentwaysbasedonthesettingofthethirdmodebutton.Thesemodesaredescribedbelow:
InvertedOutputMode
BottommodeLEDwillbeoninthismode.Inthismodetheoutputwillbeinverted.Insteadofrangingfrom-5Vto+5V,theoutputwillrangefrom
+5Vto-5V.WhentheenvelopeorLFOisnotrunning,theoutputwillsitat+5V.
AbsoluteValueMode
BottommodeLEDwillbeblinkinginthismode.Inthismodetheoutputwillproduceanabsolutevalueandwillonlygofrom0Vto+5V.Byusingthe
Stepsmodeinthelowestsetting,youcancreate+5Vpulsesandgatestodriveothermodules.
NormalMode
BottommodeLEDwillbeoffinthismode.Inthismodetheoutputwillrangefrom-5Vto+5V.WhentheenvelopeorLFOisnotrunning,theoutput
willsitat-5V.
AudioandControlVoltages
KilpatrickAudiostrivestomakeproductswiththemostconvenientanduniversalvoltagestandardspossible.Webelieveintheapproachthat
everythingshouldbeabletopatchintoeverythingandthereforeallourmodulesarebasedaroundthemostuniversal-5Vto+5Vrange.Pulsesand
gatesare0Voff/+5Von.Pitchvoltagesrangefrom-5Vto+5Vandusethestandardized1voltperoctavescaling.Audio,LFOandenvelope
voltagesalsorangefrom-5Vto+5V.Thisgivestheabsolutebestcompatibilitybetweendifferentmoduletypes.Ournon-Eurorackproductsalso
followthissamesystem.
WheneveryouseeanoffsetcontrolononeofourmodulesthatismixedwithaCVinput,thereisaneasywaytopicturehowitworks.Simply
imaginetheoffsetcontrolsettingthevalueoftheparticularfunctionwithnoinputsignal.(ora0Vinputsignal)PuttingaCVsignalintothe
correspondinginputjackwillsimplyaddorsubtractfromthisoffsetsetting.Someinputshaveattenuatorcontrols(wecallthemLEVEL)thatallow
youtoscaletheinputsignal.Thissimplyscalesdowntheinputsignalbeforeitcanaffecttheinternalcircuitry.
NeedHelp?
Feelfreetocontactusformoreinformation,toreporterrorsorunclearsections,ortorequestspecificinformationbeaddedtothismanual.
/