METERSUK
L
T
D
Manual
Multi-Fuel Prepayment System
GAS & WATER
s a l e s @ m e t e r s . c o . u k 0 1 5 2 4 5 5 5 9 2 9
MOUNTING
The SmartLink45 is designed for wall mounting, a screw
case hanging position is located at the top in the centre
of the case with two wall fixing positions located under the
terminal cover.
Wall Mounting
Wall Fixing Positions
SmartLink
45
WIRING
Wiring standards must conform to IEE regulations.
It is recommended to use shielded cable manufactured to BS4360 Class 5 or VDE0295 Class 5
Wiring block list - Terminals are marked on the PCB
Remove Terminal Cover to expose wiring block
SURGE PROTECTION is recommended
POWER SUPPLY
100AMP SINGLE POLE
Prepayment Applications only
PULSE CABLES IN
GAS
WATER
NOT USED
MODEM
CONTACTOR
CONTACTOR
POWER SUPPLY
230 or 24V
(as stated on front cover)
Independent
Manual
BEFORE TURNING THE METER ON - PLEASE DO THE FOLLOWING TO TEST THE MODEM SIGNAL:-
MOVE the modem
until signal strength
is higher.
CREDIT READINGS
SCREENS
EMERGENCY CREDIT AVAILABLE
EMERGENCY CREDIT USED
EMERGENCY CREDIT
PLEASE NOTE ONCE ALL THE EMERGENCY DEBIT AMOUNT HAS BEEN USED IE. MAX AMOUNT MINUS £ 5.00 - ALL UTILITIES WILL BE TURNED OFF
Once the Debit (DB) or EMERGENCY credit has been used, when you next top-up, the amount will be deducted off
the amount credited. ie. Used Credit £ 7.00 - Top up £ 10.00 = Available Credit £ 3.00
To activate the EMERGENCY CREDIT facility press and hold both the and BLUE GREEN
buttons together for 5 seconds.
SCREEN 1
SCREEN 2
SCREEN 3
SCREEN 1
CR - CREDIT - GAS ON
DB - DEBIT - GAS OFF
EC - EMERGENCY CREDIT - GAS ON
ED - EMERGENCY DEBIT - GAS OFF
Once signal strength is satisfactory, please switch the meter off.
Switch the meter back on without pressing any buttons and the DEFAULT screen will display.
The following screens are available to view.
NEXT / SCROLL DEFAULT TO MAIN SCREEN
ABOVE 66% BELOW 33%
33% - 66%
CR £ 0.00
WA 0.0 m³
GA 0.0 m³
DEFAULT SCREEN
CREDIT amount available on the meter. This will be shown in pounds.
BEFORE you turn on the power to the meter, press and hold the and together. BLUE Button GREEN Button
Continue to hold both buttons, switch on the power and keep holding. The meter will run through various screens and will then
display WAITING..... Continue to press and hold both buttons for around a minute until the SIGNAL STRENGTH shows on the
screen. This is an indication of the modem strength and need to be correct, otherwise the readings will not be reliable.
GAS usage total in cubic metres.
WATER usage total in cubic metres
s a l e s @ m e t e r s . c o . u k | W h i t e L u n d I n d u s t r i a l E s t a t e L a n c a s t e r L A 3 3 B T | 0 1 5 2 4 5 5 5 9 2 9
SmartLink
45
/
