Airflow Fan with Mood Lights
K362 v002: 24/12/21
Please read and retain these instructions for future reference
Important
WARNINGS AND SAFETY INSTRUCTIONS:
WHEN USING ELECTRICAL APPLIANCES, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE FOLLOWED:
• READ ALL INSTRUCTIONS BEFORE USE.
• FOR DOMESTIC INDOOR USE ONLY.
• DO NOT USE OUTDOORS OR FOR COMMERCIAL USE.
• BEFORE USE, CHECK THOROUGHLY FOR ANY DEFECTS AND DO NOT USE IF DEFECTS ARE FOUND.
TAKE CARE NOT TO DROP THE APPLIANCE AS HEAVY IMPACTS MAY CAUSE INTERNAL DAMAGE.
• BEFORE CONNECTING THE APPLIANCE, CHECK IF THE VOLTAGE INDICATED ON THE BOTTOM OF THE
APPLIANCE IS IN ACCORDANCE WITH THE MAINS VOLTAGE IN YOUR HOME.
• CHECK THE APPLIANCE AND POWER CABLE CAREFULLY FOR DAMAGE BEFORE EACH USE.
• THIS APPLIANCE CAN BE USED BY CHILDREN AGED FROM 8 YEARS AND ABOVE, AND PERSONS WITH
REDUCED PHYSICAL, SENSORY OR MENTAL CAPABILITIES OR LACK OF EXPERIENCE AND KNOWLEDGE
IF THEY HAVE BEEN GIVEN SUPERVISION OR INSTRUCTION CONCERNING USE OF THE APPLIANCE IN
A SAFE WAY AND UNDERSTAND THE HAZARDS INVOLVED. CHILDREN SHALL NOT PLAY WITH THE
APPLIANCE. CLEANING AND USER MAINTENANCE SHALL NOT BE MADE BY CHILDREN WITHOUT
SUPERVISION.
• CHILDREN OF LESS THAN 3 YEARS SHOULD BE KEPT AWAY UNLESS CONTINUOUSLY SUPERVISED.
• SOME PARTS OF THIS PRODUCT CAN BECOME VERY HOT AND CAUSE BURNS. PARTICULAR
ATTENTION HAS TO BE GIVEN WHERE CHILDREN AND VULNERABLE PEOPLE ARE PRESENT.
Dimensions
(W) 30 x (D) 18 x (H) 57cm
Material: ABS
Length of mains lead: 1.5m
• 3 SPEED SETTINGS – LOW MEDIUM HIGH.
• 7.5 HOUR TIMER
• QUIET IN OPERATION
• WEIGHT: 2.9 KG
• TIMER: 30 MINUTES UP TO 7.5 HOURS
• LIGHTING: OFF, WHITE, GREEN, PURPLE, BLUE –
COLOUR CHANGING OPTIONAL.
• AIR VOLUME: 35.2 M3/HR
• MAX FAN SPEED: 1200R/MIN
• HIGH SPEED MOTOR
• REMOTE CONTROL FITS LITHIUM BUTTON CELL
BATTERY (CR2025)
• POWER SUPPLY: 220-240V~50-60Hz
• RATED INPUT: 50W
• SMOOTH OSCILLATION.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
• THE USE OF ANY ACCESSORY OR ATTACHMENTS NOT RECOMMENDED BY COOPERS OF STORTFORD
MAY CAUSE INJURIES AND INVALIDATE ANY WARRANTY YOU MAY HAVE.
• DO NOT LET THE POWER CABLE HANG OVER THE EDGE OF A TABLE OR COUNTER, OR TOUCH HOT
SURFACES.
• DO NOT PLACE ON OR NEAR HEAT SOURCES.
• USE ON A LEVEL, STABLE SURFACE.
• DO NOT COVER THE ITEM IN ANY WAY WHEN IN USE AS THIS MAY CAUSE OVERHEATING.
• DO NOT USE THIS APPLIANCE FOR ANY OTHER USE THAN THE INTENDED USE IT IS DESIGNED FOR.
• ENSURE THERE IS SUFFICIENT DISTANCE BETWEEN THIS APPLIANCE AND OTHER ITEMS ON THE
WORK SURFACE OR WORK STATION OR SUFFICIENT DISTANCE BETWEEN THE APPLIANCE AND THE
CONFINES OF THE AREA IN WHICH IT IS SITUATED. WE RECOMMEND A MINIMUM CLEARANCE
AROUND ALL FACES OF AT LEAST 10CM.
• TO PROTECT AGAINST ELECTRIC SHOCK, DO NOT IMMERSE POWER CABLE, PLUG OR APPLIANCE, IN
WATER OR ANY OTHER LIQUID.
• UNPLUG FROM OUTLET WHEN NOT IN USE AND BEFORE CLEANING.
• DO NOT OPERATE ANY APPLIANCE WITH A DAMAGED POWER CABLE OR PLUG OR AFTER THE
APPLIANCE MALFUNCTIONS OR HAS BEEN DAMAGED IN ANY MANNER. WE RECOMMEND THAT THE
POWER CABLE IS NOT KINKED OR STORED IN A TWISTED MANNER, AND THAT YOU REGULARLY
CHECK ITS CONDITION.
• ANY REPAIRS MUST BE CONDUCTED BY A QUALIFIED ELECTRICIAN OR ELECTRICAL SERVICE AGENT.
• DISCONNECT THE POWER FROM THE UNIT BEFORE DISMANTLING, ASSEMBLING OR CLEANING THE
UNIT.
• AVOID TOUCHING ANY MOVING PARTS OF THE APPLIANCE.
• NEVER INSERT FINGERS, PENCILS OR ANY OTHER OBJECTS THOUGH THE GUARD
• DO NOT CLEAN THE UNIT BY SPRAYING IT OR IMMERSING IT IN WATER.
• NEVER CONNECT THE UNIT TO AN ELECTRICAL OUTLET USING AN EXTENSION CORD. IF AN OUTLET IS
NOT AVAILABLE, ONE SHOULD BE INSTALLED BY A QUALIFIED ELECTRICIAN.
• ALWAYS PLACE THE UNIT ON A DRY AND STABLE SURFACESURFACE. DO NOT MOVE OR TILT THE
UNIT
• HIGH VELOCITY FANS ARE DESIGNED TO CREATE RAPID AIR MOVEMENT, THEREFORE MAKE SURE
THE FAN IS NOT PLACED NEAR CURTAINS OR ANY OBJECTS THAT MAY BE DRAWN INTO THE FAN
INLET.
• THE APPLIANCE SHOULD NOT BE INSTALLED IN LAUNDRY OR WET ROOMS
• DO NOT USE THIS UNIT IN ENVIRONMENTS WITH FLAMMABLE AND EXPLOSIVE GASES.
• AVOID KEEPING THE UNIT IN DIRECT SUNLIGHT FOR A LONG PERIOD OF TIME
• THE REMOTE CONTAINS A LITHIUM BATTERY, KEEP OUT OF REACH OF SMALL CHILDREN. SEEK
MEDICAL ADVICE IF SWALLOWED.
Energy Saving and Unit Safety Protection Tips
• Do not cover or re strict the airflow . Do not use in dusty environment.
• For maximum performance the minimum distance from a wall or objects should be 50cm.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
Warning:
To reduce the risk of fire or electrical shock, DO NOT USE THIS FAN with any SOLID-STATE Speed Control
Device or any variable speed controllers.
Parts Diagram
OPERATION
Your fan may be operated by using either the manual controls located on the front of the fan or by your
remote control.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
1.ON/OFF BUTTON
Used to turn the bladeless fan ON and OFF.
2.SWING BUTTON
Press to turn the Swing function on and off. When it is operational the horizontal direction of the airflow is
slowly moved from side to side.
3.SPEED BUTTON
Press to cycle through the three available fan speeds. Low, Med, High.
4.TIMER BUTTON
Press repeatedly to increase the running time in 30-minute intervals. The timer can be set between 30
minutes and 7.5 hours. Addition of the lights will show the time set. i.e., if the 4h and 1h lights are lit, the
timer is set to 5 hours.
5.COLOUR BUTTON
Press to cycle through the options for the ambient light – Off, White, Green, Purple or Blue. The light can be
operated independently to the fan.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
Remote Control
REPLACING THE BATTERIES
The remote control is powered by a Lithium Button Cell Battery (CR2025). Should the remote become
unresponsive, replace the battery following the instructions below:
1. 1.Turn over the remote and press tab A to the right.
2. 2.Slide out the battery tray B
3. 3.Replace the battery with the same type, ensuring the positive side is facing upwards.
Your bladeless fan is supplied with a remote, which allows full
control of all the units’ functions.
ON/OFF : Turns the fan On and Off
SPEED: Cycles between the fan speeds – Quiet, Standard and
Turbo
TIMER: Press repeatedly to set the On timer in 30 minute
intervals.
The time set will be displayed on the unit.
SWING: Press to turn the Swing Function On and off.
AMBIENT LIGHT BUTTONS
– WHITE, GREEN, PURPLE AND BLUE:
Press the appropriate button to turn on the colour of ambient
light required. Press the same button again to turn off the
ambient light.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
MAINTENANCE CLEA NING AND STORAGE
ATTENTION:
Please shut off the unit and unplug from the mains before cleaning or performing any maintenance.
Cleaning the surface
• Clean the fan with a duster or a soft wet cloth.
• Do not use chemical solvent solvents (such as benzene, alcohol or gasoline) as they may cause
irreversible damage. Make sure no water enters the control panel or fan motor Do not run the unit until
completely dry.
• Place the fan in its original box or cover the fan to protect it from dust.
• Store it in a cool dry place.
Troubleshooting
Do not repair or disassemble the unit by yourself, unauthorized repair attempts will invalidate the warranty
and may cause bodily harm.
BATTERIES
• Keep batteries away from children and pets.
• Do not mix used and new batteries.
• Remove the batteries if left for long periods.
• Never dispose of batteries in a fire.
• Spent or expired batteries must be properly disposed of and recycled in compliance with local
regulations. For detailed information, contact your local authority.
• Follow the battery manufacturer’s safety, usage, and disposal instructions.
Airflow Fan with Mood Lights K362 Instructions for Use
Please read and retain these instructions for future reference v001: 15/11/21
PLUG WIRING (UK & IRELAND)
This appliance is fitted with a BS 1363 10-amp plug. If you have to replace the fuse, only those that are ASTA
or BSI approved to BS1362 and with a rated current of 10-amps should be used. If there is a fuse cover fitted,
this cover must be re-fitted after changing the fuse. If the fuse cover is lost or damaged the plug must not be
used. Spare fuse holders and fuses are available from electrical outlets. If the socket outlets in your home or
office are not suitable for this product’s plug, the plug must be removed and disposed of safely. Attempts to
insert the plug into the wrong socket is likely to cause electric hazard. A replacement plug should be wired
according to the following instructions:
The cable
A mains electricity cable contains two or three inner wires. Each has a core of copper and an outer layer of
flexible plastic. This product is earthed; the wires in the cord set are colour coded in the following way:
BLUE NEUTRAL
BROWN LIVE
GREEN & YELLOW EARTH
The diagram shows the key features of a correctly wired
three-pin mains plug.
DISPOSAL
• Coopers of Stortford use recyclable or recycled packaging where possible.
• Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
• Plastics, polybags – Contains the following recyclable plastic.
• At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.
-
1
-
2
-
3
-
4
-
5
-
6
-
7
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI