Carefully flip the table over onto its legs. Attach all four 9” leg
braces with the 4” lag screws as show in Figure 5.
Note: Make sure the table top is parallel to the bench rail before
attaching leg braces.
Figure 5
Attach the table brace with 3 1/2” bolts, nuts, & washers to the
table top as shown in Figure 6.
Nut & washer on
bottom.
Three inch bolt through
top.
5” Lag Screw
Figure 6
4”
4”
Attach the bench boards with 4” bolts, nuts & washers as
shown in Figure 7 with the 4” bolts, nuts, & washers. Then
attach other end to the bench rails with a 5” lag screw as
shown in Figure 8. (If necessary adjust bench rails to allow
the bolts to drop into the holes of the bench.)
Tighten all nuts, screws, and lag screws firmly until pieces are tight to-
gether. Your table is now ready for use.
If you have any hardware left over after
completing your unit, it most likely has
been assembled incorrectly, and may not
be safe to use. Please call customer service
Check all nuts and bolts for tightness
before and during each usage season.
STEP 7
STEP 6
STEP 5
STEP 4
4” 4”
4”
washers
& nuts
washers
& nuts
Figure 8
Nut & washer on bottom.
Three inch bolt through top.
Figure 7
Factory: 1 Lakeland Place, Edmore, Michigan 48829 Phone: (800)-427-5136 * Fax: (989) 427-5824
www.lakelandmills.com