Astria Fireplaces COMPASS Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
COMPASS
Category
Fireplaces
Type
Instruction Sheet

This manual is also suitable for

Figure 1 - Hand Bent Brackets
Figure 2 - Remove Left And Right Hand Side Screws
INSTALLATION INSTRUCTIONS FOR FIREBOX LINER KITS
[For Use with Astria® CompassDLX and Compass Series and Superior® DRL2000 & DRL3500 Series DV Linear Fireplaces]
PORCELAIN LINER KITS
901012-00
Rev. A 01/2020
HEARTH PRODUCTS
KITS AND ACCESSORIES
PACKAGING LIST
1 ea. Left Side Panel
1 ea. Right Side Panel
1 ea. Rear Panel
1 set. Panel Retainer Brackets
1 ea. Installation Instructions
TOOLS / SUPPLIES NEEDED
Safety Glasses
Protective Work Gloves
Power Drill, and 5/16” Hex Bit Tool
Porcelain Firebox Liner Kits
Cat. No. Model Description
F4244 PLK-BLK-RNCL35 Porcelain Liner Kit, 35, Black
F4245 PLK-BLK-RNCL45 Porcelain Liner Kit, 45, Black
F4246 PLK-BLK-RNCL55 Porcelain Liner Kit, 55, Black
Table 1
GENERAL INFORMATION
Do NOT install the firebox liner kit until the fireplace has been
completely installed, the gas line has been connected and
tested for leaks, and the burner operation has been verified.
READ ALL THE STEPS BEFORE STARTING THE INSTALLATION
THE FIREPLACE MUST BE OFF AND COLD BEFORE BEGINNING.
ALL WARNINGS, PRECAUTIONS AND INSTRUCTIONS IN THE
INSTALLATION AND OPERATION MANUAL PROVIDED WITH
THE APPLIANCE APPLY TO THESE INSTRUCTIONS.
If you encounter any problems, need clarification of these
instructions or are not qualified to properly install this kit,
contact you local distributor or dealer.
If any of these parts are missing or damaged, contact your
dealer or IHP.us.com for referral information.
IMPORTANT NOTE: Do not force the panels. Excessive force
may cause breakage. If the panels are correctly positioned, they
will fit snugly in place.
INSTALLATION INSTRUCTIONS
1. Follow the procedure “Turning Off Gas To Unit”, located on the
Lighting Instructions pullout labels in the control compartment of the
unit and in the Installation Instructions provided with the appliance.
2. Remove barrier screen per instructions in the Installation and
Operation Instructions manual provided with appliance.
3. Remove glass door per instructions in the Installation and Operation
Instructions manual provided with appliance.
4. Locate the bracket kit, remove two (2) flat brackets and hand bend to
resemble brackets in Figure 1. Only two (2) of the four (4) brackets
are used for this installation (see Figure 1).
5. Remove the left and right hand side screws from lintel (Figure 2)
and install brackets on each side (Figure 3).
NOTE: The lintel can be swung to allow easier installation.
Lintel
Flat Brackets
Right Side
Bracket
Installed
Left Side
Side View of Bracket
Installed around the Lintel
Lintel
Bracket
Installation Instructions
901012-00A 01/2020
Innovative Hearth Products
Porcelain Firebox Liner Kits
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Printed in U.S.A. © 2019 Innovative Hearth Products
P/N 901012-00 Rev. A 01/2020
Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice, in design, materials, specifications, and prices, and also to discontinue colors, styles, and
products. Consult your local distributor for fireplace code information.
IHP
1769 East Lawrence Street • Russellville, AL 35654
Figure 3 - Install Brackets on Each Side
Figure 5 - Install Right Side Panel
Figure 6 - Install Left Side Panel
6. Once brackets are placed on the lintel, reinstall the two screws back
into the lintel.
7. Remove the three (3) firebox liner panels from the packing materials.
8. Carefully position the rear panel, upper edge first, with base on ledge
in the firebox against the rear wall (Figure 4).
9. While holding the rear panel, carefully slide the right side panel into
the firebox and bend retainer brackets around lintel and panel to
secure in place (Figure 5).
10. Carefully slide the left side panel into the firebox and bend retainer
brackets around lintel and panel to secure in place (Figure 6).
11. Carefully install the glass media and any listed accessory media,
glass door, and barrier screen assembly. Refer to the instructions in
the Installation and Operation manual included with the appliance.
Figure 4 - Carefully Position Rear Panel
Rear Panel
Right Panel
Left Panel
Lintel
Bracket
(see Figure 1, Page 1)
Bracket
(see Figure 1, Page 1)
Lintel
Bracket
(see Figure 1, Page 1)
Lintel
  • Page 1 1
  • Page 2 2

Astria Fireplaces COMPASS Instruction Sheet

Astria Fireplaces
Brand
Astria Fireplaces
Model
COMPASS
Category
Fireplaces
Type
Instruction Sheet
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents