Astria Fireplaces DRT63ST Instruction Sheet

Brand: Astria Fireplaces

Model: DRT63ST

Type: Instruction Sheet

This addendum is in addition to the Installation and Operation

Manuals provided with IHP Electronic gas appliances listed to

Z21.88 / CSA 2.33 (standard for Vented Gas Fireplace Heaters)

and are sold in areas where local codes prohibit use of ﬁreplaces

with standing or continuous pilots (CPI).

DISABLING THE CPI INSTRUCTIONS:

NOTE: Standing Pilots are not allowed in areas where local

codes prohibit use of ﬁreplaces with standing or continuous

pilots (CPI), therefore the CPI function must be disabled per

these instructions.

SIT Proﬂame I System (see below)

Disconnect the 2 wires from the IPI/CPI switch (see Figures 1A & 1B)

1) Remove the switch and discard

2) CPI function will be disabled

NOTE: The Fireplace shall not be operated in the continuous

pilot mode.

Addendum for Disabling the

CPI (continuous pilot ignition)

feature on IHP Electronic Gas

Appliances

P/N 900949-00 Rev. NC 12/2018

For more information, visit IHP.US.com

Figure 1A - SIT Proﬂame I System (Fixed Valve)

Figure 1B - SIT Proﬂame I System (Adjustable Valve)

Figure 2 - SIT Proﬂame II System

SIT Proﬂame II System (see below)

1) Cut gray jumper wire on module (see Figure 2)

2) Once the gray jumper wire is cut the CPI function on the

remote control will be disabled

NOTE: The Fireplace shall not be operated in the continuous

pilot mode.

Gray jumper wire

Disconnect Wires, Remove

and discard switch

Disconnect Wires, Remove

and discard switch

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

P/N 900949-00 Rev. NC 12/2018

Innovative Hearth Products (IHP) reserves the right to make changes at any time, without notice,

in design, materials, speciﬁcations, prices and also to discontinue colors, styles and products.

Consult your local distributor for ﬁreplace code information.

1769 East Lawrence Street • Russellville, AL 35654

Figure 3 - Skytech System

Skytech System (see below)

1) Disconnect the 2 wires from the IPI/CPI switch

2) Remove the switch and discard

NOTE: The Fireplace shall not be operated in the continuous pilot mode

Disconnect Wires, Remove

and discard switch

Astria Fireplaces DRT63ST Instruction Sheet

Astria Fireplaces DRT63ST Instruction Sheet

Astria Fireplaces DRT63ST Instruction Sheet

Related papers

Other documents