Allied Brass RC-5/16-CA Installation guide

13.50

Drilled Hole

Bracket

GLRT-16

SCREW

BRACKET

DRILLED HOLE

ANCHOR

Step 1:

Determine your desired location for installation and make a mark for the location of the mounting bracket. Make 2 marks

where mounting screws will be placed as shown below. Make sure shelf is level when marking for location of installation.

Drill hole at each end of the marks.

Drill holes in Wall for screw anchors

Attach Shelf to mounting Surface

Step 2:

RC-5-16

INSTALLATION INSTRUCTIONS

No portion of this document or any artwork contained herein should reproduced in any way without the written conset of ALLIED BRASS INC.