BLUEGRASS LIVING 170166 User manual

Type
User manual
CORNER COMBO
WOOD FIREPLACE MANTEL
MODEL FBD28TCC-M-HC/MO
Questions, problems, missing parts? Before returning to your retailer, call
our customer service department at 1-866-573-0674, 7:30 am - 4:15 pm CST,
Monday through Friday or email customerservice@usaprocom.com
www.usaprocom.com 200087-01A2
39.33"
99.9 cm
43.46"
110.38 cm
21"
53.34 cm
15"
38.1 cm
F
A
B
E
D
H
C
GG
PRODUCT SPECIFICATIONS
PACKAGE CONTENTS
If a part is missing or damaged, return to place of purchase
(exterior wood components are not replaceable).
Item Part # Description Qty
AFBD28-M1-401-MO/HC Top 1
BFBD28-M1-402-MO/HC Panel 1
CFBD28-M1-403-MO/HC Left Side Panel 1
DFBD28-M1-404-MO/HC Right Side Panel 1
EFBD28-M1-405-MO/HC Base 1
FFBD28-M1-406-MO/HC Top Triangle Panel 1
GFBD28-M1-407-MO/HC Backboard 2
H SJ001 Set Square Support 1
www.usaprocom.com 3200087-01A
FF
GG
HH
II
WARNING: When tightening screws, do not over tighten, this may cause
threads to strip. We recommend using a hand-held screwdriver rather than
a power screwdriver.
WARNING: Do not force screws into holes.
CAUTION: For corner installations(optional); if baseboards are installed
where the replace is intended to be displayed, the replace will not t ush
against the wall. For a proper ush t, it may be necessary to remove part
of the baseboard mold.
HARDWARE CONTENTS
REPLACEMENT PARTS LIST
AA
BB
CC
DD
EE
PREPARATION
Before beginning assembly of product, make sure all hardware contents parts are present. Compare parts with package contents list and diagram
on page 4. If any part is missing or damaged, do not attempt to assemble the product. Contact customer service for replacement parts.
Estimated Assembly Time: 60 minutes
Tools Required for Assembly: Phillips Screwdriver, Flathead Screwdriver, Drill, and Tape Measure.
Item Description Part # Qty
Hardware Package HP006 1
AA Cam Dowel PCAM-023 16
BB Cam Lock PCAM-023 16
CC Wall Anchor ML066-01 2
DD ST4 Screw 1 3/16" GB/T 951 4×30 8
EE ST5 Screw 2 3/8" GB/T 950 5×60 2
FF ST4 Screw 5/8" GB/T 951 4×16 18
GG Connector Bracket SJ002 3
HH White Key ML067-01 1
II ST4 Screw 1 9/16" GB/T 951 4×40 8
www.usaprocom.com 200087-01A4
ASSEMBLY INSTRUCTIONS
1. Insert Cam Locks (BB) into Panel (B). Screw Cam Dowels (AA) into
the Left Side Panel (C) and the Right Side Panel (D). Attach Panel
(B) into assembled frame (C, D) by tightening the Cam Locks (BB)
as shown in Figure 1.
Figure 2
Figure 1
Figure 3
Hardware Used
Hardware Used
Hardware Used
AA
AA
AA
II
BB
BB
BB
4) Cam Dowel
6) Cam Dowel
6) Cam Dowel
4) ST4 Screw 1 9/16"
4) Cam Lock
6) Cam Lock
6) Cam Lock
2. Insert Cam Locks (BB) into the Left Side Panel (C) and the Right
Side Panel (D). Screw Cam Dowels (AA) into Base (E). Attach
Base (E) into assembled frame by tightening the Cam Locks (BB)
as shown in Figure 2.
3. Fasten the wood support brackets attached to the Left Side (C)
and Right Side (D) Panels with ST4Screw 1 9/16" (II) to the Base
(E) as shown in Figure 3.
C
C
C
D
D
D
B
BB
BB
AA
AA
II
E
E
For Corner Mantel, skip to step 8, page 7.
4. Insert Cam Locks (BB) into assembled framel (B,C,D). Screw Cam
Dowels (AA) into Top (A). Attach Top (A) into assembled frame by
tightening the Cam Locks (BB) as shown in Figure 4.
Figure 4
Hardware Used
BB
AA
A
C
D
B
www.usaprocom.com 5200087-01A
ASSEMBLY INSTRUCTIONS
5. Fasten the wooden support brackets attached to the top of the
mantel assembly to the Top (A) with ST4 Screw 1 9/16" (II) as shown
in Figure 5.
Figure 6
Figure 5
Figure 7
Hardware Used
II 4) ST4 Screw 1 9/16"
6. After assembling the mantel, lift to the upright position. Carefully,
push the replace insert from the front of the mantel as shown in
Figure 6.
7. Position the replace to the desired location as shown in Figure 7.
Fireplace Insert
Wall
II
A
www.usaprocom.com 200087-01A6
ASSEMBLY INSTRUCTIONS
Figure 10
Figure 11
II
DD
4) ST4 Screw 1 9/16"
8) ST4 Screw 1 3/16"
Hardware Used
Hardware Used
10. Fasten the wooden support brackets attached to the top of the
mantel assembly to the Top (A) with ST4 Screw 1 9/16" (II) as shown
in Figure 10.
11. Attach the left and right Backboard (G) trim pieces to the back of
the replace with ST4 Screw 1 3/16" (DD) as shown in Figure 11.
II
A
G
DD
Figure 8
Figure 9
Hardware Used
Hardware Used
AA
FF
BB
GG
6) Cam Dowel
18) ST4 Screw 5/8"
6) Cam Lock
3) Connector Bracket
8 . Turn the replace Top Panel (A) over. Using the supplied Connector
Brackets (GG), attach the Mantel Top (A) to the Top Triangle Panel
(H) with ST4 Screw 5/8" (FF) as shown in Figure 8.
9. Insert Cam Locks (BB) into Panel (B), the Left Upper Panel (C)
and the Right Upper Panel (D). Screw Cam Dowels (AA) into Top
(A). Attach Top (A) into assembled frame by tightening the Cam
Locks (BB) as shown in Figure 9.
CORNER APPLICATION
A
H
GG
FF
BB
AA
A
C
D
B
www.usaprocom.com 7200087-01A
31 1/2"
41 1/2
"
1 9/16"
ASSEMBLY INSTRUCTIONS
Figure 13
Figure 14
Figure 15
Figure 12
CC
CC
2) Wall Anchor
Hardware Used
12. After assembling the mantel, carefully lift to the upright position.
Push the replace insert from the front of the mantel as shown in
Figure 12.
13. Drill two holes (5/16") in the corner where the replace is to be
displayed. Drill the rst hole 37 7/8" from the ground up. Drill the
second hole 1 9/16" from the rst hole as shown in Figure 13. Place
the Wall Anchors (CC) into holes by pinching the anchor tabs
together as shown in Figure 13.
14. Install the Set Square Support (H) to the holes drilled in step 13,
with ST5 Screw 2 3/8" (EE) as shown in Figure 15. This block is
used to support the Top Triangle Panel (F). For thin walls, insert
white key (HH) into wall anchor and push to “pop” open anchor
wings.
15. Push replace into the corner so that the Top Triangle Panel (F) is
resting on top of the Set Square Support (H) as shown in Figure 15.
Hardware Used
EE
HH
2) ST5 Screw 2 3/8"
1) White Key
Mitered Corner
Joints
Mitered Corner
Joints
Baseboard
HH
H
EE
Fireplace Insert
H
F
37 7/8"
30 3/4"
200087-01
Rev. A
07/13
REGISTER YOUR PRODUCT AT WWW.USAPROCOM.COM
IMPORTANT: We urge you to register your product within 10 days of date of installation, complete
with entire serial number which can be found on the rating plate. Please ll out the warranty infor-
mation above for your personal records. Retain this manual for future reference.
Always specify model and serial numbers when communicating with customer service.
We reserve the right to amend these specications at any time without notice. The only warranty applicable
is our standard written warranty. We make no other warranty, expressed or implied.
LIMITED WARRANTY
ProCom Heating, Inc. warrants this product to be free from defects in materials and components for
TWO (2) years from the date of rst purchase, provided that the product has been properly installed by a
qualied installer in accordance with all local codes and instructions furnished with the unit, operated and
maintained in accordance with all applicable instructions. To make a claim under this warranty, the Bill of
Sale or cancelled check must be presented.
RESPONSIBILITY OF OWNER
This warranty is extended only to the original retail purchaser. This warranty covers the cost of part(s)
required to restore this heater to proper operating condition. Warranty part(s) MUST be obtained through
ProCom Heating, Inc. who will provide original factory replacement parts. Failure to use original factory
replacement parts voids this warranty. The heater MUST be installed by a qualied installer in accordance
with all local codes and instructions furnished with the unit.
WHAT IS NOT COVERED
This warranty does not apply to parts that are not in original condition because of normal wear and tear or
parts that fail or become damaged as a result of misuse, accidents, lack of proper maintenance or defects
caused by improper installation. Travel, diagnostic cost, labor, transportation and any and all such other
costs related to repairing a defective heater will be the responsibility of the owner.
TO THE FULL EXTENT ALLOWED BY THE LAW OF THE JURISDICTION THAT GOVERNS THE SALE
OF THE PRODUCT, THIS EXPRESS WARRANTY EXCLUDES ANY AND ALL OTHER EXPRESSED
WARRANTIES AND LIMITS THE DURATION OF ANY AND ALL IMPLIED WARRANTIES. INCLUDING
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE TO TWO (2)
YEARS ON ALL COMPONENTS FROM THE DATE OF FIRST PURCHASE. PROCOM HEATING, INC.'S
LIABILITY IS HEREBY LIMITED TO THE PURCHASE PRICE OF THE PRODUCT AND PROCOM HEAT-
ING, INC. SHALL NOT BE LIABLE FOR ANY OTHER DAMAGES WHATSOEVER INCLUDING INDIRECT.
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow a limitation on how long an implied warranty lasts or an exclusion or limitation of
accidental or consequential damages, the above limitation on implied warranties, or exclusion or limitation
on damages may not apply to you.
This warranty gives you specic legal right, and you may also have other rights that vary from state to state.
WARRANTY
KEEP THIS WARRANTY
Model _______________________________
Serial No. ____________________________
Date Purchased _______________________
Keep receipt for warranty verication.
ProCom Heating, Inc.
Bowling Green, KY 42101
www.usaprocom.com
1-866-573-0674
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

BLUEGRASS LIVING 170166 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI