Kmart 42773641 User manual

Type
User manual
1 2 3
4 5 6
1. Cut out the tattoo graphic
of your choice. Make sure
skin is clean and dry.
1. Slide the buttons
next to the top light
bulbs to unlock the
mirror panel. This
panel can be used
independently.
2. Install batteries
on back of mirror.
3. Adjust the supporting
leg on back of mirror
to stand alone.
4. Press button on right
of lighting panel to
turn on/off lights.
2. Remove the plastic film
on sticker.
3. Put tattoo face down on skin
and apply pressure for
30 seconds.
4. Wet the tattoo thoroughly
with a sponge.
5. Peel off the paper backing. 6. Wait for the tattoo to dry
out itself.
Apply baby oil on the tattoo. Wait for 10 seconds.
Then rub gently and repeatedly with more baby
oil until removed.
Do not apply tattoo to sensitive skin or near eyes.
If irritation occurs, wash with soap and water,
and seek medical attention immediately.
■ Do not look at the lights directly.
■ Do not install or take out the light panel and batteries without adult supervision.
■ Close the handheld case slowly to avoid injury.
How to remove: Warning:
Instructions
1 2 3 4
  • Page 1 1

Kmart 42773641 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages