Garden Spike
Excluding 2 x E27 max 100W PAR38 230V
ILLUSTRATIONS
O28
PRODUCT CODE
ENVIRONMENTAL PROTECTION
Waste electrical & Electronic equipment regulations requires that any of our products
showing this marking must not be disposed of with other household or commercial
waste. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, please separate any such products from other waste types and recycle it
responsibly at your local facilities.
Cape Town - 9 Racecourse Road, Milnerton, 7441
Johannesburg - 10 Milkyway Avenue, Linbro Business Park, Sandton, 2065
www.eurolux.co.za
Please read instructions before commencing installation and retain for future reference.
3. Fasten Screw
1. Unscrew
2. Connect wires
To connector block
• Fitting Material: Plastic
• Lamp type: Excluding 2 x E27 max 100W PAR38 230V
• Voltage: 220 - 240V ~ 50/60Hz
• Protection against electric shock: Class 2 does not Require Earthing.
• IP Rating: 44
• Commercial / domestic use
• Maximum Ambient temperature range: 20ºC - 40ºC
• Dimensions: (H)395mm x (W)400 x (D)75mm
attachments:
If the external exible cable or cord of this luminaire is damaged, it should be exclusively replaced
by the manufacturer or his service agent or a similar qualied person in order to avoid a hazard.To
ensure that you get maximum longevity and maximum use out of your luminaire, please observe
the following safety instructions.
Electrical products can cause death, injury, or damage to property. Installation of the luminaire
must be carried out by a qualied electrician, in accordance with SANS 10142. On completion
of installation, ensure that the Certicate of Compliance is updated.
• Before connecting the luminaire, ensure that voltage indicated on the rating label
corresponds with the mains voltage in your home.
• When changing the lamp, ensure that the power is turned o.
• Ensure that the correct lamp type and wattage is tted.
• This luminaire is checked in full for conformity to the quality standards and safety requirements.
• The manufacturer / supplier is not responsible for any damage of properties and persons,
caused by the incorrect use or installation of the luminaire.
• Should you be unsure of how to install this luminaire correctly, please consult a professional
electrician or your supplier for assistance.
• Ensure all items/ components, threads and screws are tightly secured.
IMPORTANT:
• Tampering with this luminaire, i.e.using silicon sealers or incorrect cabling, will invalidate
your warranty.
• When the protection glass is damaged, it should be replaced immediately. The luminaire
must not be used without the protection glass.
• Please check whether the connection of the power cord is safe and reliable before installation.
• If your mains wiring diers in any way from diagram, consult a qualied electrician.
• Always ensure that the mains supply voltage is correct.
• Choking hazard: May contain small parts. Keep away from children.
• Do not insert your ngers or any part of your body into the electrical contact and sockets of
this product whilst it is connected to the electrical supply.
• Item may vary slightly from the picture on the carton.
• Always replace the lamp with one of an identical rating and wattage.
SPECIFICATIONS
IMPORTANT SAFEGUARDS
INSTALLATION
Before installation always ensure the power supply is turned o.
• When installing this tting use surface or norsk cable.
• Always use approved cable for installations.
• Use conduit to protect the cable where it is exposed above ground and where trenches are made
below ground.
• Always bury any electrical cable at least 0.5m underground.
• Cables buried at least 0.5m deep are less likely to be damaged by garden tools.
• For any outside wiring installation, always use weatherproof equipment.
• Remember to turn o the electrical current at the main switch before starting any
underground wiring.
• Connect the tting to power ensuring to use appropriate IP rated glands and water
tight connectors.
• NOTE: Do not bury the junction box below ground level .
• NOTE: Always allow the lamp to cool suciently before changing.
Garden spike lights are exible light tting and can be used for numerous areas to
illuminate small trees and shrubs as well as garden ornaments and water features.
FIXTURES
CLEANING
• Before cleaning always ensure the power supply is turned o.
/
