Peerless DS-C555-3X3 User manual

Category
Multimedia carts & stands
Type
User manual
12014-05-30 #:009-9086-4 (2014-12-09)
ENG
DS-C555-3X3
46" - 55"
(117 - 140 cm) 900 lb
(409 kg)
MAX
22014-05-30 #:009-9086-4 (2014-12-09)
This page intentionally left blank.
32014-05-30 #:009-9086-4 (2014-12-09)
Heavy
(13mm)
Do not begin to install product until you have read and understood the instructions and warnings contained in
this user guide. Always use an assistant or mechanical lifting equipment to safely lift and position equipment.
This product must be installed onto at, hard, level surface to prevent tipping. The cart or stand is not af xed or
secured to the oor, and may therefore tip over and/or fall if screen and/or stand is shaken or hit. Displays must
be removed before moving cart. Not recommended for use in areas with heavy traf c. This product is intended
for indoor use only. Use of this product outdoors could lead to product failure or personal injury. Screws must
be tightly secured. Do not overtighten screws or damage can occur and product may fail. Never exceed the
Maximum Load Capacity. Be careful not to pinch ngers when operating the mount. For support please call
customer care at 1-800-865-2112.
WARNING
To properly tighten screws: Tighten until screw
head makes contact, then tighten another 1/2
turn. Do not overtighten screws.
1
2
+1/2
4
3
Symbols
ENG
WARNING
ENG
Display center.
ENG
x3
Screws must get at
least three full turns
and t snug.
ENG
Do not overtighten screws.
ENG
Tools Needed for Assembly.
ENG
42014-05-30 #:009-9086-4 (2014-12-09)
Parts (Before beginning, make sure you have all parts shown below).
Parts List
Part #
Description Qty
Acaster, 5" swivel 4 600-0026
Bcaster support 4 145-T1799
Ccover 6 145-T1809
Dbase leg 2 145-T1767
Ehorizontal leg support 1 145-T1785
Fbase support tube 2 145-T1812
Gbase support 6 560-T1261
Hvertical leg support 2 145-T1777
Ileg support extension 2 145-T1778
Jadaptor bracket 18 145-T1792
Kside support bracket 4 145-T1807
Lvertical support bracket 6 145-T1806
Mcomputer cover 1 145-T1930
Ncomputer shelf 1 145-T1931
Odual cross support 3 145-T1924
Pextension adaptor 2 145-T1935
Qlocking tab 4 145-T1936
Rcord bracket 4 145-T1929
Scross support 3 145-T1816
Tplate connections 6 145-T1821
UM8 x 16mm socket button screw 168 520-9527
VM8 square nut 92 530-1066
Wcover clip 24 590-0317
XM5 x 10mm type-F, socket pin screw 20 520-1164
YM5 x 12mm socket pin screw 4 520-1064
Z1/4" power bit 1 560-0263
AA 5mm allen wrench 1 560-9640
BB nylon shoulder washer 36 590-2233
CC M6 x 12mm socket pin screw 36 520-1050
DD 4mm allen wrench 1 560-9646
A (4)
caster B (4)
caster support C (6)
cover
D (2)
base leg
E (1)
horizontal leg
support
F (2)
base
support tube
G (6)
base support
H (2)
vertical leg
support
L (6)
vertical support
bracket
K (4)
side support
bracket
I (2)
leg support
extension
J (18)
adaptor bracket
52014-05-30 #:009-9086-4 (2014-12-09)
S (3)
cross support
DD (1)
4mm allen
wrench
M (1)
computer cover
R (4)
cord bracket
O (3)
dual cross
support
U (168)
M8 x 16mm V (92)
M8 square
nut
W (24)
cover clip X (20)
M5 x 10mm Z (1)
1/4" power
bit
AA (1)
5mm allen
wrench
Y (4)
M5 x 16mm
BB (36)
nylon shoulder
washer
CC (36)
M6 x 12mm
Q (4)
locking tab T (6)
plate
connections
P (2)
extension
adaptor
N (1)
computer shelf
62014-05-30 #:009-9086-4 (2014-12-09)
1
U (4)
A
B
U (2)
V (2)
Repeat for each caster assembly.
Do not fully tighten hardware
SIDE VIEW
(5mm)
AA
72014-05-30 #:009-9086-4 (2014-12-09)
2
U (4)
U (4)
F
F
V (2)
V (2)
D
V (2)
V (2)
Repeat for each base leg assembly.
(5mm)
AA
82014-05-30 #:009-9086-4 (2014-12-09)
Casters must be ush to end of horizontal leg support.
Horizontal leg support.
ENG
ENG
3
Repeat for each base leg assembly.
TIGHTEN
CONNECTING
HARDWARE
CASTER MUST
BE FLUSH
WITH LEG
92014-05-30 #:009-9086-4 (2014-12-09)
5
Repeat for each side (x2).
H
4
Repeat for each base support (x6).
V (4)
G
U (4)
TIGHTEN
CONNECTING
HARDWARE
Do not fully tighten hardware
SIDE VIEW
10 2014-05-30 #:009-9086-4 (2014-12-09)
Repeat for each extension
adaptor (x2).
Do not fully tighten hardware.
7-1
U (4)
V (4)
P
6
E
TIGHTEN
CONNECTING
HARDWARE
LOCK WHEELS
Do not fully tighten hardware
TOP VIEW
11 2014-05-30 #:009-9086-4 (2014-12-09)
I
P
TIGHTEN
CONNECTING
HARDWARE
7-2
12 2014-05-30 #:009-9086-4 (2014-12-09)
8
DISPLAY HEIGHT
DISPLAY HEIGHT
Repeat for each vertical
support bracket (x6).
U (4)
U (2)
V (4)
L
1/8"
(3mm) 1/8"
(3mm)
TIGHTEN
CONNECTING
HARDWARE
TIGHTEN
TIGHTEN
13 2014-05-30 #:009-9086-4 (2014-12-09)
9
Repeat for each cross support (x3).
U (8)
O
S
T
V (4)
T (2)
14 2014-05-30 #:009-9086-4 (2014-12-09)
10
TIGHTEN
HARDWARE
(X2)
TIGHTEN
HARDWARE
(X2)
TIGHTEN
CONNECTING
HARDWARE (X4)
Must install bottom row rst.
Cross supports must center on vertical leg supports.
15 2014-05-30 #:009-9086-4 (2014-12-09)
11
TIGHTEN
HARDWARE
(X2)
TIGHTEN
HARDWARE
(X2)
TIGHTEN
CONNECTING
HARDWARE (X4)
Must install middle row second.
Cross supports must center on vertical leg supports.
16 2014-05-30 #:009-9086-4 (2014-12-09)
12
TIGHTEN
HARDWARE
(X2)
TIGHTEN
HARDWARE
(X2)
TIGHTEN
CONNECTING
HARDWARE (X4)
Must install top row last.
Cross supports must center on vertical leg supports.
17 2014-05-30 #:009-9086-4 (2014-12-09)
13
R
Q
Y
TIGHTEN
CONNECTING
HARDWARE
TOP VIEW
R
Q
Y
18 2014-05-30 #:009-9086-4 (2014-12-09)
Side support brackets (K) must center on cross supports.
14
KU (2)
V (2)
OPTIONAL: Unlock wheels to move cart to
desired location; Lock wheels before hanging
screens.
LOCK WHEELS
19 2014-05-30 #:009-9086-4 (2014-12-09)
x3
BB CC U
OR
.98"
(25mm)
2.50"
(63mm) 15.75"
(400mm)
7.87"
(200mm)
0.91"
(23mm)
3.94"
(100mm)
2.50"
(63mm)
X
X
15
Center adaptor brackets vertically on back of screen.
20 2014-05-30 #:009-9086-4 (2014-12-09)
16-1
16-2
Must hang displays to bottom row rst; Secure pin
in "locked" position.
Must hang displays to middle row second; Secure
pin in "locked" position.
"LOCKED"
POSITION
"LOCKED"
POSITION
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8
  • Page 9 9
  • Page 10 10
  • Page 11 11
  • Page 12 12
  • Page 13 13
  • Page 14 14
  • Page 15 15
  • Page 16 16
  • Page 17 17
  • Page 18 18
  • Page 19 19
  • Page 20 20
  • Page 21 21
  • Page 22 22
  • Page 23 23
  • Page 24 24
  • Page 25 25
  • Page 26 26
  • Page 27 27
  • Page 28 28

Peerless DS-C555-3X3 User manual

Category
Multimedia carts & stands
Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI