Elkay 51300C_12PK Installation guide

Brand: Elkay

Model: 51300C_12PK

Type: Installation guide

This manual is also suitable for

EWF3000

Page 1 98526C (Rev. H - 06/16)

WaterSentry Plus Retro Bottle Filler and Water Cooler

7a. Turn on water supply and hold open the bubbler on cooler

 untilapproximately1gallonofwaterisdispensed.Thisushing

 procedurepurgesairandnecarbonparticlesfromthelter.

When 1 gallon of water has been purged through the cooler,

carefully inspect all water connections for leaks.

Theselterkitsaredesignedtobeusedwiththefollowing

Elkay products.

Filtered EZH2O® Bottle Filling Station Models

Examples include but not limited to: LZWS*, LZS*WS,

LVRC*WS, LMABF*WS

NOTICE: Do not use with water that is microbiologically

unsafe or of unknown quality without adequate

disinfection before or after the system. Filter

 mustbeusedwithltermonitorfor3000

gallon rating

General Installation Instructions

1. Theselterkitsmust be installed in compliance with all

state and local laws and regulations governing the

installation and use of this product. Maximum inlet

water temperature 100°F (38°C).

2. Mountlterheadinasuitablelocation,usingthelter

mounting bracket and screws supplied. Allow enough

 roomunderthelterheadforinstallationandremovalof

 ltercartridge(13"minimum).

3. Connectthecoldwatersupplytothelterthrougha

 shut-offvalveand3/8"O.D.tubing(suppliedbythe

installer). For ease of servicing, the shut-off valve

 shouldbelocatedwithineasyreachofthelter.

 NOTE:Theinletandoutletttingsuppliedas

 partofthelterheadareJohnGuestSuperseal

 ttingsthataccept3/8"O.D.tubingonthelter

 inletand1/4"O.D.tubingontheoutlet.Theymay

be used with copper, semirigid nylon or

polypropylene tubing, with a rated working

pressure equal or greater than encountered in

application. Do not use soft or braided tubing.

4. CAUTION: If supply pressure will ever exceed

100 psi, install a pressure regulator to limit the

 inletpressuretothelterto100psiorbelow.

 DONOTATTACHHOTWATERLINETOFILTER.

 Tomakeconnectionsonthelterhead,loosenlocknut.

Push the tube end past both o-rings to a positive stop in

 thelterheadrecess-approx.1",locknutmayhaveto

be backed out a little more. Screw the locknut hand tight

to seal (See Fig. 1). Ends of tubing must be cut square

and free of burrs and sharp ends that could cut or nick

the o-rings.

5. Connect the outletoftheltertotheinletoftheunion

 usingthe1/4"O.D.polytubingand1/4"unionsupplied.

6. Removelterfromcarton, remove protective cap, attach

 ltertolterheadbyrmlyinsertingintoheadand

 rotatinglterclockwise.

Filter Replacement

1. Turn inlet water valve off.

2. Open bubbler or activate the electric eye to relieve pressure

build-up in the system.

3Removeusedlterfromheadbyrotatingltercounterclockwise.

4.Removenewlter from carton, remove protective cap; cap may

 beplacedonoldltertoreducethechanceofwaterspillingfrom

 lterhousing.

5.Attachltertolterheadbyrmlyinsertingintoheadand

 rotatinglterclockwise.

NOTE:Thelterheadcontainsanautomaticshut-offvalvethat

stops the ow of water, if the lter is removed inadvertently

without shutting off the incoming water.

WaterSentry Plus In Wall Bottle Filler

7b. Turn on water supply and activate the electric eye on In-Wall

Bottle Filler until approximately 1 gallon of water is dispensed.

Please note that the electric eye activation times out at 30

seconds and will need to be activate repeatedly until one gallon

 hasbeenpassed.Thisushingprocedurepurgesairandne

 carbonparticlesfromthelter.When1gallonofwaterhas

 beenpurgedthroughthebottleller,carefullyinspectallwater

connections for leaks.

FILTER KIT

EWF3000WaterSentry® Plus Kit

(Lead, Aesthetic Chlorine Taste & Odor & Particulate Class I Reduction)

FOR COMMERCIAL USE ONLY

The Elkay® WaterSentry® Plus is certied by WQA to NSF/ANSI Standard 42 and 53 for the

reduction of AestheticChlorine,TasteandOdor,ParticulateClassI,andLead,asveriedand

substantiated by test data.

NOTE: This system and installation shall comply with applicable

state and local regulations.

(NOTE:CTOreplacementlterisonlycertiedtoNSF42claims;seeWSF6000RPerformance

Data Sheet for additional information.)

IMPORTANT NOTE - To avoid danger of an electric shock hazard, disconnect power to

yourunitbeforeinstallingorreplacingthelter.

B CA

SIMPLY PUSH IN

TUBE TO ATTACH

TUBE IS SECURED

IN POSITION

PUSH IN COLLET

TO RELEASE TUBE

OPERATION OF QUICK CONNECT FITTINGS

PUSHING TUBE IN BEFORE

PULLING IT OUT HELPS TO

RELEASE TUBE

OPERATIONOFQUICKCONNECTFITTINGS

SIMPLYPUSHIN

TUBETOATTACH

TUBEISSECURED

INPOSITION

PUSHINCOLLET

TORELEASETUBE

PUSHINGTUBEINBEFORE

PULLINGITOUTHELPSTO

RELEASETUBE

A B C

FIG. 2

FIG. 1 SeeNote4:Screwthelocknuthandtighttoseal

Page 2

98526C (Rev. H- 06/16)

Table A

REPLACEMENT FILTER

Part No. Description

Lead,TasteandOdorFilter51300C

FIG.3

ELKAYWaterSentry® Plus

Filter

NOTE: Performance will vary depending on local water conditions.

Pressure (Max.)

Pressure (Min.)

FlowRate

RatedCapacity

Temperature (Max.)

Temperature (Min.)

RATED OPERATING CONDITIONS

105PSI(7.4Kg/cm2)

20PSI(1.4Kg/cm2)

1.5GPM(5.7LPM)

3,000Gallons(11,358L)

100° F (38° C)

40° F (5° C)

LZS* LZSTL*

FILTER

LOCATION

FILTER

LOCATION

WaterSentry® Fresh WSF6000R CTO(replacementonly)

FIG.4 FIG. 5

Item

No. Part No. Description

FilterAssembly-3000Gallons

Kit-FilterHeadFittingIncludesJohnGuestFtgs

Assy-Filter&BracketIncludesFilterHead/

MtgBracket/JohnGuestFtgs/Screws

See Table

98926C

0000000746

2 2

*Note:Bracketcanbeturnedovertoprovidebettertinsomemodels.

Page3 98526C (Rev. H - 06/16)

Seepage4forreplacementinformation.

INSTALLATION WHEN USED

WITH WATER CHILLER

PLUMB FILTER OUTLET DIRECTLY

TOIN-WALLBOTTLEFILLER

IF NO CHILLER IS USED

TOBUBBLER

1/4"POLYTUBE

1/4"

TEE

1/4"x1/4"UNION

1/4"POLYTUBING

CHILLER

OUTLET

3/8"POLYTUBING

TOBOTTLE

FILLER

TOBUBBLER

1/4"STEM

ELBOW

FILTER

ASSEMBLY

1/4"TEE

1/4"POLYTUBING

1/4"POLY

TUBING

3/8"CU

WATER

INLET

TOBUBBLER

1/4"x1/4"X3/8"TEE

1/4"POLYTUBING

TOBUBBLER

FILTER

ASSEMBLY

3/8"CU

WATER

INLET

3/8"POLYTUBING

TOBOTTLE

FILLER

FIG.6

FIG.7

1/4"x1/4"X3/8"TEE

Page4

98526C (Rev. H- 06/16)

ToreceivemaximumbenetfromyourELKAYWaterSentry®lters,notetheinstallationdatesbelowand

change according to the following guidelines.

REPLACEMENT FILTER OPTIONS

ELKAYPartNo.51300CWaterSentry® Plus — Lead Reduction Filter

Changeevery3,000gallonsasindicatedbytheltermonitor,oronceayear–whicheveroccursrst.

PartNo.WSF6000RWaterSentry® Fresh — CTO Filter

Changeevery6,000gallonsasindicatedbytheltermonitor,oronceayear–whicheveroccursrst.

NOTICE

FORPARTS,CONTACTYOURLOCALDISTRIBUTORORCALL1.800.834.4816

ELKAYMANUFACTURINGCOMPANY•2222CAMDENCOURT•OAKBROOK,IL60523•630.574.8484

www.Elkay.com

DATE

INSTALLED

MODEL

(TYPEOFFILTER)

SERVICE

PERSON

DATE

INSTALLED

MODEL

(TYPEOFFILTER)

SERVICE

PERSON

– KEEP THIS SHEET IN A HANDY LOCATION –

Elkay 51300C_12PK Installation guide

Brand: Elkay

Model: 51300C_12PK

Type: Installation guide

This manual is also suitable for

EWF3000

Download PDF

report

Elkay 51300C_12PK Installation guide

This manual is also suitable for

Elkay 51300C_12PK Installation guide

Related papers

Other documents