Santeg 61356 Installation guide

  • I have reviewed the installation guide for the Santeg 61356 toilet surrounding. This document includes important disclaimers about the warranty, requirements for pre-installation checks, detailed dimensions, a list of parts and tools needed, and step-by-step assembly instructions to ensure correct installation. I'm ready to answer any questions you may have about the product or its installation process.
  • What happens if I install the product differently from this manual?
    What should I check before installation?
    What is accepted when I proceed with installation?
Toilet surrounding to be tiled 135x120x22
61356
61356 _INSTALL_INT_ver2020.1.3
Disclaimer
If you install the product in a way that differs from this manual, this will void all guarantees. Before installation check that the product meets all your requirements and is not
damaged. By proceeding with installation, you accept the condition of the product.
Disclaimer
Indien u het product plaatst op een manier die afwijkt van deze handleiding, vervalt alle garantie. Controleer voor plaatsing of het product aan al uw eisen voldoet en niet
beschadigd is. Indien u overgaat tot plaatsing, aanvaardt u de staat waarin het product zich bevindt.
Clause de non-responsabilité :
Si vous installez le produit d’une manière différente de celle présentée dans ce manuel, toutes les garanties seront invalidées. Contrôlez avant le placement si le produit répond
à toutes vos exigences et n’est pas endommagé. En procédant au placement, vous acceptez l’état dans lequel se trouve le produit.
Haftungsausschluss
Wenn Sie das Produkt nicht genau nach den Angaben in dieser Montageanleitung einbauen, verfällt die Garantie. Überprüfen Sie vor dem Einbau des Produkts, ob sämtliche
Voraussetzungen erfüllt sind und das Produkt nicht beschädigt ist. Sobald Sie mit der Montage beginnen, sehen Sie, in welchem Zustand sich das Produkt bendet.
Installationguide
Installatiegids
Guide d’installation
Montageanleitung
PARTSLIST
A
B
C
D
Technical drawing - Technische tekening
Dessin technique - Technische Zeichnung
1200
200
200
20 1350
303
408
438
600
510
Ø40
Ø70
Ø115
180
Tools needed
B
E
F
21
Assembly - Montage - Montage - Montage
A
43
76
8
OR
5
Ø 4 mm
B
B
C
D
E
109
24 h
12
11
13
>10X10cm
F
/