Balt 94CAC-96 Assembly Instructions

Type
Assembly Instructions
2
3
Enclosed Bulletin Board
Hardware List
A Angle Bracket
B Long Screw
C Short Screw
D Screw Anchor-Concrete
E Screw Anchor-Drywall
P1 Bulletin Board Front
P2 Bulletin Board Back
Parts List
Enclosed Bulletin Board_6-24-13
1
Place your Bulletin Board Back (P2)
on the wall at the point you want it
mounted. Make sure it is level. Mark
a line across the top and along
the bottom edges.
Note:
Install four Masonry Anchors (D)
into 1/4” Diameter predrill
holes for masonry walls.
Install four Drywall Anchors (E)
into 1/4”Diameter predrill holes
for sheet rock walls. E
D
Place the Bulletin Board Back (P2) on the bottom
Angle Brackets and secure with Short Screw (C)
through brackets. Push the top Angle Brackets
down onto the Bulletin Board back and secure
with Short Screws (C).
C
P1
45
P2
P1
Hook the Bulletin Board Front (P1) over the
flange at the top of the Bulletin Board
Back (P2). Swivel the front down and use the
Key Lock to secure in place.
Remove the protective film
after the unit is installed.
P2
Measure up 1 1/2” from the bottom Pencil Line and 2” in from each end. Drill a 1/8”
hole at these two points. Use a Long Screw (B) through an Angle Bracket (A) and
into the predrilled holes for the bottom mounts. Measure down 1” from the top Pencil
Line and 2” in from each end. Drill a 1/8” hole at these two points. Use a Long Screw
(B) through an Angle Bracket (A) and into the predrilled holes for the top mounts.
Make sure Angle Brackets (A) are turned as drawing shows. This Step in the
instructions is for a wood/stud wall. See the NOTE above for other type walls.
1”
1 1/2”
Bottom
Pencil Line
Top Pencil
Line
2”
2”
1/8” Predrill 1/8” Predrill
  • Page 1 1

Balt 94CAC-96 Assembly Instructions

Type
Assembly Instructions

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI