Radio operation
1. To switch on, turn the volume controller VOLUME / BUZZ
g
, until an audible
»Click« is heard.
2. Using the volume controller VOLUME / BUZZ
g
now set the desired volume.
3. Set the waveband selector switch
;
to the desired wavelength range
(FM/AM).
4. Adjust the tuning wheel
f
to select the desired radio station. The frequencies
can be read off from the frequency scale
y
.
5. To switch off, turn the volume controller VOLUME / BUZZ
g
until an
audible »Click« is heard (KH 2201.Turn the volume controller upwards,
KH 2202: Turn the volume controller to the rear).
Setting up the telescope aerial
On Model KH 2201:
• Extend the telescope aerial
w
completely.
The telescope aerial
w
on Model KH 2201 is not rotatable.
If you try to turn the telescope aerial
w
, the aerial mounting will be damaged.
On Model KH 2202:
• Remove the telescope aerial
w
from its retainer and set it up.
• Extend the telescope aerial
w
completely.
To improve reception in the FM frequency range, slowly turn the end of the
telescope aerial
w
in various directions. As soon as you have found a position
with good reception from your desired radio station, leave the telescope aerial
w
in this position. For the reception of AM transmitters, an aerial is built into
the appliance. For improved reception, alter the position of the appliance in
radio mode.
- 9 -
