Groen DEE/4T-40 TA/3 Datasheet

Brand: Groen

Model: DEE/4T-40 TA/3

Category: Electric kettles

Type: Datasheet

This manual is also suitable for

DEE/4T-60 TA/3

Groen DEE/4T-40 TA/3 is a self-contained, tilting, electric heated, stainless steel 2/3 steam jacketed cooker/mixer with twin shaft agitator assembly.

The kettle interior is made of 316 stainless steel with a solid, one-piece, welded construction. The kettle is mounted on a heavy duty stainless steel, combination kettle support tilt trunnion which is supported by the polished stainless steel enclosed base.

The kettle is furnished with a heavy duty reinforced rim with a butterfly-shaped pouring lip for maximum sanitation and ease of pouring. The base is provided with stainless steel tubular legs with adjustable flanged feet. The enclosed support base contains a self-locking worm and gear tilt mechanism, contactor, etc., and shall be of sanitary drip-proof construction with the interior readily accessible for installation or maintenance.

Groen DEE/4T-40 TA/3 is a self-contained, tilting, electric heated, stainless steel 2/3 steam jacketed cooker/mixer with twin shaft agitator assembly.

Applications

Meats

Soups

Stews

Sauces

Pie fillings

Pudding

Beans

Powdered mixes

Icings

Custards

Cooker/Mixer

models DEE/4T-40 TA/3 & DEE/4T-60 TA/3

Groen Cooker/Mixer, Page 3

141048C

Revised 08/09

Stainless Steel

2/3 Steam Jacketed

Cooker/Mixer

Floor Mounted

Tilting

Self-Contained

Electric Heated

40 and 60-Gallon

Capacities With

Twin Shaft Agitator

Short Form

Groen Model DEE/4T-40 or 60,

TA/3 (specify gallons) self-con-

tained, tilting, electric heated,

stainless steel 2/3 steam

jacketed cooker/mixer with

twin shaft agitator assembly

standard, one with multiple

scraping fingers and the sec-

ond agitator is counter rotat-

ing mixer. Base shall house,

positive lock, smooth-action,

manual-tilt assembly. 316

stainless steel kettle interior

has solid, one-piece, welded

construction with heavy-duty

reinforced rim and butterfly-

shaped pouring lip. Twin shaft

agitator mounted on console

with mechanically assisted tilt-

out and positive quick action

rim lock and latch. Unit is

standard with 2” TDO valve

and etch marks. Kettle is NSF

and UL Listed, ASME code con-

structed for 50 PSI. Standard

208 volt, 3-phase for kettle,

208 volt, 3 or 1-phase for agi-

tator motor. Made in USA.

Description

Cooker/Mixer shall be a Groen Model DEE/4T-40 or 60,

TA/3 gallon (specify 40 or 60) stainless steel, self-con-

tained, 2/3 steam jacketed unit operating from an electric

heated steam source contained within unit and complete

with console mounted tilt out twin shaft scraper mixer.

Construction

Kettle interior shall be of 316 stainless steel, solid one-

piece welded construction. The control console and kettle

exterior shall be 304 stainless steel. The kettle body shall

be mounted on a heavy duty stainless steel, combination

kettle support tilt trunnion which is supported by the pol-

ished stainless steel enclosed base. The kettle shall be

furnished with heavy duty reinforced rim with a butterfly

shaped pouring lip for maximum sanitation and ease of

pouring. The base shall be provided with stainless steel

tubular legs with adjustable flanged feet. The enclosed

support base shall contain a self-locking worm and gear

tilt mechanism, contactor, etc., and shall be of sanitary

drip-proof construction with interior readily accessible

for installation or maintenance. Unit includes 2” TDO and

10-gallon etch markings and double pantry faucet.

Finish

Interior of kettle shall be polished to a 180 emery grit

finish. Exterior of kettle shall be finished to a bright semi-

deluxe finish, ensuring maximum ease in cleaning and

maintaining brilliant appearance.

Agitator Assembly

Enclosed transfer case to be cast aluminum with a 3-to-1

gear ratio. Gear motor to be completely enclosed-type,

cast iron housing, right angle shaft down, helical bevel

gearing, variable speed motor driven through an elec-

tronic speed control. See table on back for minimum and

maximum agitator speeds.

Main agitator to be anchor-type, shaped to the contour

of the kettle and provided with removable nylon finger

scrapers. The secondary counter-rotating bar type

agitator shall be centrally-located between the center

shaft and the outside arms of the main agitator. Both

agitators are attached with bayonet connections for easy,

quick removal for cleaning or when kettle is to be used

without the mixing mechanism. Both agitators are 304

stainless steel and either can be used alone. Agitator

and motor drive assembly can be manually tilted to the

right side of kettle.

ASME Code & UL Listing

Unit shall be ASME shop inspected, stamped and reg-

istered with the National Board for operation up to a

maximum working pressure of 50 PSI. Kettle is UL listed.

Sanitation

Unit shall be designed and constructed to meet NSF

requirements, and be NSF listed.

Self Contained Steam Source

Kettle shall have an electrically heated self-contained

steam source to provide kettle temperatures of 150°F to

approximately 295°F. Unit shall be factory charged with

water and rust inhibitors to ensure long life and minimum

maintenance.

Controls

Controls shall include a thermostat, built in contactor,

pressure gauge, water sight glass, heat indicator lamp,

tilt safety switch, agitator on-off switch and double-pantry

faucet with bracket.

Agitator to be electronic, variable speed control-type capa-

ble of operation at any RPM between minimum and maxi-

mum settings.

Safety Features

Kettle shall have safety cut-off (cuts off heat when tilted to

12°F and above), pressure relief valve, high limit pressure

switch and low water cut off, 24V control system, and agi-

tator safety tilt cut off.

Options/Accessories

Disk strainers (not to be used with agitator)

240, 480 Volt power supply

(specify for kettle or motor)

Kettle brush kit

Pan carrier

Wall mount with in-wall carrier

Gallon master

Basket insert

Lip strainers

Contour measuring strips

Installation Requirements

Unit requires two electrical connections, standard 208 volt,

3-phase for kettle; Standard 208 volt, 3-phase for agitator

motor.

Origin of Manufacture

Cooker/Mixer shall be designed and manufactured in the

United States.

Model DEE/4T-60, TA/3 shown

1055 Mendell Davis Drive, Jackson, MS 39272

888-994-7636, uniﬁedbrands.net

Please reference our website for the most

updated product information and speciﬁcations.

DI Foodservice Company

1055 Mendell Davis Drive

Jackson, MS 39272

difoodservice.com

Telephone (601) 372-3903

Toll Free (800) 676-9040

FAX (601) 373-9587

info@groen.com

DEE/4T-40or-60,TA/3

141048

Revised 11/05

Due to continuous product improvement, designs are subject to change without notice.

Stainless Steel

2/3 Steam Jacketed

Cooker/Mixer

16-1/2

749

879

1025

387

546

1854

1613

1460

749

362

318

29-1/2

14-1/4

12-1/2

63-1/2

57-1/2

40-3/8

15-1/4

21-1/2

29-1/2

42-1/4

2070

81-1/2

31-1/2

12-3/8

314

419

800

68-3/4

61-1/2

1746

1562

1121

44-1/8

23-1/2

13-1/4

597

337

44-1/8

927

787

660

DIM.

MODEL

40 GAL.

INCH

26A

TABLE OF DIMENSIONS

60 GAL.

INCH

762

AGITATOR MOTOR DATA SPECIFICATIONS

RPM MAIN

MINIMUM

MAXIMUM

H.P.

1-1/2 150

RPM SECONDARY 240V 3PH

4.8 A

2.8 A

480V 3PH

2.4 A

1.4 A

462 120

6.2 A

3.6 A

3.1 A

1.8 A

MINIMUM

MAXIMUM

208V 3PH

5.3 A

3.1 A

6.9 A

4.0 A

ELEC. LOAD RATING

GAL

59 A

105 A

61 A

29 A480 V

3 PH

240 V

24 KW

LOAD

101 A

VOLTAGE PHASE

1 PH208 V

KETTLE POWER ELECTRICAL TABLE

POWER

21 KW

3 PH

1 PH

3 PH

(1194)

(737)

A ID

CLERANCE INCLUDING

HANDLE & LATCH DEVICE

6 MIN

(152)

7-1/2" MAX.

(191)

6-1/2

(165)

(257)

2-3/16

(165)

3-1/2

(89)

MIN. POUR PATH

KETTLE IN

TILTED POSITION

TANGENT DRAWOFF

(OPTIONAL)

ELECTRICAL CONNECTION

FOR KETTLE 1" IPS

ADJUSTABLE FEET

MAX. POUR PATH

6 MIN (152)

REAR WALL

CLERANCE

WALL

(152)

ELECTRICAL

CONNECTION

FOR MIXERS

3/4" IPS

13 1/16

(332)

140906 REV. A

9-1/4

(235)

6 (152)

MIN.

SIDE WALL

CLERANCE

CONTROL BOX MAY BE

MOUNTED REMOTELY TO

AN ADJACENT WALL

(BY CUSTOMER)

11 5/8

(295)

36 7/8

(937)

4 1/2

(114)

3 1/2

(89)

1 1/4

(32)

P/N 140906 REV A

Models DEE/4T-40 TA/3 & DEE/4T-60 TA/3

1055 Mendell Davis Drive, Jackson, MS 39272, 888-994-7636, uniﬁedbrands.net

trademarks in the United States [and various other countries] of Uniﬁed Brands, a

wholly-owned subsidiary of Dover Corporation.

Groen DEE/4T-40 TA/3 Datasheet

Brand: Groen

Model: DEE/4T-40 TA/3

Category: Electric kettles

Type: Datasheet

This manual is also suitable for

DEE/4T-60 TA/3

Groen DEE/4T-40 TA/3 is a self-contained, tilting, electric heated, stainless steel 2/3 steam jacketed cooker/mixer with twin shaft agitator assembly.

Download PDF

report

Groen DEE/4T-40 TA/3 Datasheet

This manual is also suitable for

Groen DEE/4T-40 TA/3 Datasheet

Related papers

Other documents