Back to Contents Page
Supported Features
Dell™OpenManage™ServerAdministratorStorageManagementUser'sGuide
Different controllers support different features. The tasks displayed by the Storage Management menus and other features vary depending on whether the
controller supports the feature. This appendix identifies the features that each controller supports. For more information, see your hardware documentation.
Supported Features on the PERC 3/SC, 3/DC, 3/QC, 4/SC, 4/DC, 4/Di, 4e/Si, 4e/Di,
4e/DC, CERC ATA100/4ch, and 4/IM Controllers
This section identifies the controller-supported features and whether or not an enclosure can be attached to the controller.
l "Controller Tasks"
l "Battery Tasks"
l "Connector Tasks"
l "Physical Disk Tasks"
l "Virtual Disk Tasks"
l "Virtual Disk Specifications"
l "Supported RAID Levels"
l "Read, Write, and Disk Cache Policy"
l "Enclosure Support"
For enclosure-supported tasks, see "Enclosure and Backplane Features."
Controller Tasks
Table A-1. Controller Tasks Supported by the PERC 3/SC, 3/DC, 3/QC, 4/SC, 4/DC, 4/Di, 4e/Si, 4e/Di, 4e/DC, CERC ATA100/4ch, and
4/IMControllers
Supported Features on the PERC 3/SC, 3/DC, 3/QC, 4/SC, 4/DC, 4/Di, 4e/Si, 4e/Di, 4e/DC, CERC ATA100/4ch, and 4/IM
Controllers
Supported Features on the PERC 5/E, PERC 5/i, PERC 6/E, PERC 6/I, PERC 6/I Modular, and CERC 6/I Controllers