Scotsman KSP5 - 17-2871-01 Operating instructions

For the extended splash panel kit, KSP5

1. Remove original splash panel from dispenser.

2. Slide ice and water sensors from original splash panel.

3. Plug sink drain hose with plug from the kit.

4. Insert ice and water sensors into the new splash panel.

5. Secure splash panel to dispenser using the original screws at the top and the two 5/16” bolts from

the kit at the bottom.

Note: The bolts at the bottom go into the dispenser’s shipping skid mounting

holes and require access space below the machine for panel removal.

Instructions

17-2871-01 Rev A

Bottom

Mounting

Holes

Top

Mounting

Holes