Powerhouse PH2700PRi Quick start guide

  • Hello! I am an AI chatbot trained to assist you with the Powerhouse PH2700PRi Quick start guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
®
QuickStart Guide
Please review this Quick Start Guide to begin using your generator.
To fully understand and safely operate this product, please review the
warnings and complete detailed instructions in the Owner’s Manual.
Thank you
For joining the
PoWerhoUSe FAMiLY
Please refer to the Owner’s Manual
when you see this icon for important
details and additional information.
13
www.powerhouse-products.com Rev. 2012-08-01
Avoid water
KeeP AWAY FroM rAin, SnoW
AnD other Wet ConDitionS
Use outdoors only
ProDUCeS CArbon MonoxiDe —
CAn CAUSe DeAth or SerioUS injUrY
Flammable
KeeP AWAY FroM SMoKing MAteriALS,
SPArKS, & SoUrCeS oF CoMbUStion When reFUeLing
High altitudes /
Extreme temperatures
reFer to the oWner’S MAnUAL For SPeCiFiC reCoMMenDAtionS
Keep level
ALWAYS oPerAte
on A LeveL SUrFACe
In emergency
PUSh the engine SWitCh to OFF PoSition
to StoP engine – With or WithoUt A LoAD.
Battery safety
reFer to the oWner’S MAnUAL For
MAintenAnCe AnD SAFetY reCoMMenDAtionS
I
nverter
G
enerator
PH2700PRi
What you need to
Get started
Oil (16.9 oz. of 15W-40)
Use 0W-40 in very cold weather
Gasoline (1.4 gal.)
Funnel
Phillips screwdriver
Battery charger
If you do not have a charger we recommend
the Powerhouse TC2-P charger (#19674)
12
13
Please take a few moments to register your unit at www.powerhouse-products.com/register.
If you have a problem with this generator,
do not return it to the store where you purchased it. For
warranty support call 877-544-4449, 8am to 6pm ET, or email us at [email protected].
11
1.
PH2700PRi generator
2.
Oil jug
3.
2 keys
4.
2 remotes
5.
Oil drain pipe
6.
Spare fuse
7.
Spark plug wrench
8.
Screwdriver
9.
Spare spark plug
10.
Battery charge kit
11.
Owner’s manual
Box
Contents
11
5
7
9
2
1
3
4
6
10
8
©Copyright DTS Manufacturing / The Coast Distribution System, Inc. 2012
Primer bulb
Fuel
valve
Maintenance
door
Battery access
door
Starter grip
Choke lever
Overload light (red)
Run light (green)
Low oil alarm light (red)
Economy switch
Ground terminal
Remote on indicator
Battery charge circuit breaker
Stop button (red)
Ignition switch
Parallel data port
120 V circuit breakers
Parallel receptacle
120 V duplex receptacles
Overload reset button (green)
Battery charge receptacle
Wheels
Gas cap
access door
Spark plug
access door
Control
panel
Retractable
handle
Remote switch
Initial setup
(continued)
Remove
battery
access door
Locate battery
wiring harness
12
Remove dipstick
Connect battery
wiring harness
to main wiring
harness
Replace battery
access door
3 HOURS
Connect battery
charger to
DC receptacle
Charge the battery for 3
hours or until fully charged
Remove
maintenance door
Oil resevoir
Add oil
Add 16.9 oz. (500 ml) of oil
or fill to full mark on dipstick
Initial setup (continued)
Replace
maintenance door
Add
gasoline
Use gasoline with an
octane rating of 87 or higher
13
Replace dipstick
Operation
Turn remote
switch off
16
Connect
appliances
For remote system in-
structions, refer to page
18 of the owner’s manual
18
20
Turn
key
to start
For additional
starting options
refer to pages
16-18 of the
owner’s manual
Disconnect
appliances
Open
fuel valve
Pump primer bulb
15 to 20 times
(initial startup only)
Shutdown
In emergency
push and hold the
STOP button until
the engine is off
Turn remote
switch off
Close
fuel valve
Disconnect
appliances
Turn
economy
switch on
Turn
key off
/