www.PyleUSA.com
3
CHARGING INSTRUCTIONS
Charge your Digital Voice Amplier
1. Ensure that the Digital Voice Amplier is OFF.
The Digital Voice Amplier will not charge if the
device is ON.
2. Slide the Digital Voice Amplier into the charging
unit as shown in g.4 and g.5, with the charging
connections, g.2, facing the charging light indi-
cator, g.5. The small arrow at the base of the
Digital Voice Amplier should point towards the
charging light indicator.
3. Push lightly on the Digital Voice Amplier until it
clicks into place.
4. Insert charging cable to the slot, g.6, and the other
end into the USB socket of your AC Adaptor. Switch
ON at the mains and the charging light indicator
will light up. The cable can be used with most
standard USB AC adaptors.
5. If the charging light indicator does not light up
check that the USB cable has been inserted
correctly and the mains power is switched ON.
6. The charging light indicator is red when charging.
If the charging light indicator shows red and green
together the Digital Voice Amplier has been
inserted incorrectly, remove and re-insert the
Digital Voice Amplier. Once charged the
charging light indicator will turn green.
7. A full charge takes a minimum of 2 hours, and will