Convair Climate Wizard Owner's manual

Brand: Convair

Model: Climate Wizard

Type: Owner's manual

Convair Climate Wizard is a climate control solution that addresses common problems associated with heating in winter, such as excessive temperature, dryness, static electricity, and dust. It adds moisture to the air, lowers the temperature in overheated rooms, and purifies the air using a filter that reduces airborne contaminants.

Back View

Congratulations on purchasing a

Convair ClimateWizard. Convair is a

world leader in climate control

solutions.

ClimateWizard addresses the

common problems associated with

heating in winter - excessive

temperature, dryness, static electricity

and dust - which can cause symptoms

such as skin irritations, allergies and

respiratory problems.

ClimateWizard adds moisture to the

air and lowers the temperature in

overheated and dry rooms.

ClimateWizard also purifies the air by

using an air filter which reduces

airborne contaminants.

Component List

Handle Filter cartridge clips

Controls Rear panel

Front grille Filter cartridge &

filter

Water tank

Water filling area

Water level

Rating label

window

Drain plug

Wheel

Rear panel clips

Manual

ILL1253-A

ILL1254-A

Front View

ILL1253-A

Use this appliance for the intended

use only.

Do not use this appliance outdoors.

Caution: Your ClimateWizard holds

water so be sure to move it carefully.

Do not move the appliance when it

is full of water - it is advisable to

move it into position before filling it.

Caution: Always switch your

ClimateWizard off and unplug it before

filling it with water, cleaning it or

servicing the appliance.

At the end of each season, or at least

monthly if heavily used, it is advisable

to carry out some simple maintenance

on your ClimateWizard. Refer to the

Maintenance section.

Handle Assembly

To attach the handle, push it into the

slot at the back of the appliance until it

clicks into place. The handle has

been designed to be a permanent

addition to the appliance. Do not

attempt to remove it once assembled.

Once firmly secured the handle will aid

in the appliance s manoeuverability.

Manual

Safety

When using electrical appliances

please follow these precautions to

reduce the risk of fire, electrical

shock and injury to persons.

Warning: This appliance is not

intended for use by young children or

infirm persons without supervision.

Do not use this appliance in a closed

room when only occupied by children.

Caution: Before connecting your

ClimateWizard to an electrical outlet,

check that the required voltage shown

on the rating label is the same as your

power supply.

Caution: This appliance has a

polarized plug (one blade is wider than

the other). To reduce the risk of

electric shock, this plug is intended to

fit in a polarized outlet only one way. If

the plug does not fit fully in the outlet,

reverse the plug. If it still does not fit,

contact a qualified electrician. Do not

attempt to defeat this safety feature.

To avoid accidents and fire hazards,

keep the cord out of heavy traffic

areas, never put near heat registers,

radiators or stoves. Do not use this

appliance if the plug or cord is

damaged. Caution: Do not plug in the

cord with wet hands as electric shock

may result.

This appliance is designed with a

safety feature so that if the rear panel

is removed the appliance will not

operate. Do not attempt to defeat this

safety feature.

ILL1255-A

Operation

1. Place the appliance in a central

position in your home or office.

2. Pour clean water into the opening

at the back of the appliance.

The maximum water capacity of the

ClimateWizard is 3.4 gallons (13

liters). The minimum amount of water

required to operate the pump is

gallon (1.9 liters). No damage occurs

to the appliance when it is operated

without water.

3. Fill the appliance with water until

the water reaches the maximum fill

level indicated inside the tank.

Caution: Do not overfill the

appliance as water will spill on

the floor.

4. Refill the appliance with clean water

whenever the water level in the

window is low.

5. Plug the ClimateWizard into the

electrical outlet and turn the power

on.

6. Turn the moisture control knob

( ) to the on position.

7. Turn the power knob ( ) to low

speed. Please note that

maximum moisturizing capacity

will not be reached until the

moisturizing pad is completely

saturated. This may take several

minutes.

8. If the desired comfort level is not

achieved after this time, increase

the fan speed. Lower fan

speeds provide quieter operation.

Manual

ILL1257-A

ILL1260-A

ILL1261-A

ILL1259-A

ILL1256-A

ILL1258-A

9. If your home or office becomes

uncomfortable and/or water

condensation occurs, decrease

the water flow. Turn the moisture

control knob ( ) off and/or

turn the fan knob ( ) to a lower

setting.

10.Turn your ClimateWizard off by

turning the fan knob ( ) off .

Maintenance

Ensure that the ClimateWizard is

switched off and the plug is removed

from the electrical outlet before any

maintenance is performed.

To clean the exterior of the appliance

use a damp cloth and mild household

detergent.

Note: The tank must be drained of

water before the appliance is stored.

At the end of each season, or more

often if heavily used, it is advisable to

carry out some simple maintenance

on your ClimateWizard. This will help

Manual

maintain its high performance. Follow

the steps below.

1. Drain the water from the appliance.

Move it to a drain and remove the

drain plug located on the bottom of

the tank. When the appliance is

empty replace the plug in the

tank.

. The

filter can be vacuumed or rinsed

with water, however, to maintain

maximum performance it is

recommended that filters be

replaced rather than cleaned. For

approved filter replacements call

1-800-926-6824. To gain access to

the filter, remove the filter cartridge

by disengaging the clips at the

top and pivoting it backwards.

Clean or replace the air filter every

3 months or when required

ILL1264-A

ILL1281-A

ILL1263-A

ILL1262-A

3. To gain access to the inside of the

appliance remove the rear panel by

disengaging the clips at the top.

Pivot the rear panel backwards and

lift it off. Take care when

removing the rear panel as water

may drip from the moisturizing pad

secured to the inside of the panel.

4. Wash the moisturizing pad with a

gentle spray of water while it is still

in the rear panel. Do not use a

high pressure hose to clean the pad.

Replace the pad if salt has built-up

on the pad as it will reduce the

ClimateWizard s performance.

5. Clean the tank and the perforated

water strainer located in the tank by

using a damp cloth and mild

ILL1267-A

ILL1268-A

household detergent. Do not use

abrasive cleaners or solvents.

Remove any foreign matter. This

will ensure that the strainer does

not clog up during operation.

6. If the pump drive belt needs

replacing, remove it from the

pulleys. Ensure that the belt is

replaced in the same orientation

as shown in the diagram so that

the pump rotates in the right

direction.

7. Replace the rear panel by placing

the bottom of the rear panel in the

tank and pivoting it forward until

the clips engage.

ILL1269-A

Manual

ILL1280-A

Manual

8. Replace the filter cartridge by

placing the bottom tabs on the

filter cartridge into the rear panel

and pivoting it forward until the top

clips engage.

Any additional maintenance or

servicing should only be performed by

qualified personnel. Failing to do so

may void your warranty.

ILL1266-A

ILL1265-A

EspanolManual

Condition

1. Appliance will not

operate

2. Appliance stops

operating after

running for some

time

3. No moisturizing

4. Appliance causes an

unpleasant odor

5. Appliance makes

scraping or rattling

noise

6. Water overflows from

the tank

7. Damaged power

supply cord

8. Too much moisture

or room is too cool

Possible Cause

1.1 Power outlet or supply is faulty

1.2 Wrong voltage

1.3 Electrical fault

2.1 Motor has overheated (safety

cutout)

3.1 Moisture control knob is off

3.2 Tank is empty or nearly empty

3.3 Pad and/or pump is blocked or

dirty

3.4 Pump is not working properly

3.5 Pump drive belt faulty or broken

4.1 Tank or pad is dirty

4.2 Water quality is poor

5.1 Dirt has built-up in the pump

6.1 Too much water in the tank

Remedy

1.1.1 Check the power supply

1.1.2 Check the power outlet

1.2.1 Check that the power supply is the same as

that specified on the appliance s rating label

1.3.1 Electrical parts must only be repaired and replaced

by Authorised Service Agents - call Convair

technical support at 1-800-926-6824

2.1.1 Wait 30-45 minutes for the motor to cool down. It

should restart automatically. If this condition

persists, call Convair technical support at

1-800-926-6824

3.1.1 Turn the moisture control knob to on

3.2.1 Fill the tank with water until the water reaches the

maximum water level mark (3.4 gallons)

3.3.1 Clean the parts. See Maintenance section

3.4.1 The pump is not a separate electric pump. It is

connected to the fan and motor and is driven

mechanically. Turn the appliance off and drain the

tank completely. Refill with clean water. Switch fan

knob to high speed, turn the moisture knob to on

and run the appliance for 10-15 minutes. This will

help to flush out the dirt. The pad should now be

wet. If the pad is not wet then the pump is still

clogged. Call Convair technical support at

1-800-926-6824

3.5.1 Replace the drive belt. See Maintenance section

4.1.1 Drain the tank and refill with clean water. If

the odor persists, clean the tank and clean or

replace the moisturizing pad and/or the filter pad

4.2.1 Add vanilla essence or perfume to the water

5.1.1 Clean the parts. See Maintenance section

5.1.2 Replace the drive belt. See Maintenance section

6.1.1 Drain some water out

7.1.1 If the power supply cord is damaged it should be

replaced. Call Convair technical support at

1-800-926-6824

8.1.1 Reduce the fan speed and/or turn the water off.

See Operation section

Troubleshooting

Parts List

Description

1 Badge

2 Front Panel

3 Plug & Cord Set

4 Control Box

5 Switch Wire

6 Microswitch

7 Switch

8 Capacitor

9 Control Panel

10 Knob

11 Screw

12 Water Valve

13 Hose to Spreader

14 Chassis

15 Handle

16 Motor Rubber

17 Fan

Description

18 Belt

19 Pad Retainer

20 Moisturizing Pad

21 Rear Panel

22 Air Filter

23 Filter Cartridge

24 Hose to Pump

25 Tank

26 Drain Plug

27 Strainer

28 Rear Wheel

29 Motor

30 Pump Assembly

Warranty Card

STOP label

Owner s Manual

Wiring Diagram

If you need replacement parts or have any questions call 1-800-926-6824

or visit us at www.convaircooler.com

1 2

6 7

141312

Exploded View

ILL1270-A

Convair Cooler Corporation

1202 North 54th Ave

Building 2 Suite 117

Phoenix, Arizona 85043

Phone: 602-353-8066

Fax: 602-353-8070

Toll Free: 1-800-926-6824

www.convaircooler.com

2003

828336-A 0306

Cooler Corporation

www.convaircooler.com

Convair Climate Wizard Owner's manual

Convair Climate Wizard Owner's manual

Convair Climate Wizard Owner's manual

Related papers

Other documents