RS200 Quickstart Guide
is Quick Start Guide will get music owing quickly with a Bluetooth connection
to your RS200. is way you can have some music playing while you explore the
RS200’s Owner’s Manual. Connecting to Wi-Fi, the Play-Fi app, HDMI, AirPlay and
more is explained starting on page four of the Owner’s Manual.
Power Up
• Connect AC Power to the Rear of the
RS200.
• Switch the Main Power Switch to the On (
|
)
position.
• Press and release the Right Knob on the
front of the RS200. e RS200 will power
on. When meter backlights turn on and the
red LED below the Right Knob turns o,
the unit is ready.
Pairing Mode
• Press and hold the Le Knob for two
seconds and then release.
• “BT” will blink above the Le Knob. e
RS200 is in Bluetooth Pairing Mode.
• On the phone (or other device) you wish
to connect, press SCAN in the Bluetooth
section of Settings. Generally, this is found
in the Connections’ submenu of settings
(devices may vary).
• Select “RS200 XXXX” to pair. (See gure
Below.) Answer “OK” or “Yes” if asked to
Pair.
Play
e RS200 is now connected for Audio to your
device. You can control the Volume of your
RS200 with your connected device.
Enjoy
Connect
AC Power
Main
Power Switch
McIntosh part number 241XXX
RS200 ready
to Pair
