2
1
4
5
3
You can use the camera by a DC 12V / 450mA (MAX)
The camera utilizes a CCD image sensor having a high quality picture.
Changeable Mirror/Normal images with complete waterproof knobs.
(Our own patent)
Water-resistant housing.
Operates over a wide temperature range.
Extremely clear image with high-performance IR LED at low light
(Our own patent)
Auto shutter camera
CONNECTION
Automatic heating when the temperature is below +10 C
SPECIFICATIONS
Camera input connector pin description.
C. Run the cable from the camera
to the monitor.
B. Attach the supplied mounting
bracket to the vehicle. Adjust
the angle of the camera and
fasten the screws firmly.
A. Assemble bracket & sunshield
with camera as following pictures.
Microphone
Infrared
Illuminators
M I R
NOR
Pigtail
Color Monitor
Align the marks and press
the connectors together.
Screw the "a" up clockwise
in order to prevent water
from infiltrating
Connecting Cable
(water-Resistant)
Camera Cable
To Camera Input
(4-pin Connector)
Interline transfer type CCD
NTSC : 270,000 / PAL : 20,000 pixels 3
1/3 Inch
Maximum aperture F=2.0
Internal
330TV lines
0.5 Lux Minimum
Minimum 44dB (at AGC off)
4.0W
-30 C to +50 C (-22 F to +122 F)
0.5Kg
Image
Picture elements
Image size
Lens
Synchronization
Horizontal resolution
Required illumination
Signal to noise ratio
Power supply
Power consumption
Operating temp.
Weight
Dimensions
Supplied Acc'y
Rubber Nut
(4)
W/washer 5 X 16L Stainless screw ( 4)
Camera Bracket
(1)
L-wrench 3mm
(
1)
5 X 16L Stainless screw (4)
W/washer 4 X 10L Stainless screw ( 4)
Sunshield
3mm
(1)
103(W) X 83(H) X 84(D) mm
4.0(W) X 3.3(H) X 3.3(D) Inch
DC12V
Pin No.
Description
1
2
3
4
5
Video Output
Shutter contral power (9VDC)
Audio Output
Power DC 12V
Ground
- WHITE
- BLUE
- RED
- YELLOW
- BLACK
Camera input connector pin description.
CAMERA INSTALLATION
※ Design And Specifications Are Subject To Change Without Notice.
FEATURES
BE-811C
Owner's Manual
THIS SYMBOL MEANS DO NOT DISPOSE OF
AS MUNICIPAL WASTE.
RE-USE OR RECYCLE WHEREVER POSSIBLE.
ELECTRICAL / ELECTRONIC COMPONENTS MAY
CONTAIN SUBSTANCES WHICH ARE HARMFUL TO
THE ENVIRONMENT.
FOR ENVIRONMENTALLY SOUND METHODS OF
DISPOSAL, PLEASE CONTACT YOUR LOCAL
GOVERNMENT AUTHORITY.
A LOOSE CONNECTION MAY CAUSE MALFUNCTIONING OF THE UNIT.
THE PLUGS SHOULD BE FULLY INSERTED INTO THE CONNECTORS OR JACKS.
THE GROUND TERMINAL FROM THE BATTERY FOR AVOIDING SHORT
CIRCUITS.
BEFORE MAKING THE CONNECTION , DISCONNECT
CAUTION
Please turn off the power and turn it on again when you experience
problems on the shutter function. Please try this several times.
The automatic heating system inside this camera prevent camera from
freezing during winter.
Brigade Electronics Inc. 202 Delaware Avenue,Palmerton,PA 18071,USA
Tel: (001) 6108441227 Fax; (001) 4842290088
e-mail infousa@brigade-electronics.com web: www.brigade-electronics.com
/
