AIMPIRE USB Desktop DAC Decoder DSD - Mini Audio Amplifier Decoder Aimpire DAC, DSD256 PCM44.1-384kHz/32bit, Thesycon Driver XMOS XU208 ES9018K2M OPA2134 Replaceable OP for DIY User manual

  • Hello! I am an AI chatbot trained to assist you with the AIMPIRE USB Desktop DAC Decoder DSD - Mini Audio Amplifier Decoder Aimpire DAC, DSD256 PCM44.1-384kHz/32bit, Thesycon Driver XMOS XU208 ES9018K2M OPA2134 Replaceable OP for DIY User manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1
2
Thank you for purchasing USB-DAC AD10!
AD10 is a high performance device which has three kinds of output ways
such as Optical, Coaxial and Line Out, and is compatible with 384kHz/32Bit
and DSD256. AD10 is designed to be simple and equipped with LED
display screen. It can be used as not only a DAC but also digital interface.
We believe that high-quality AD10 could bring you more fun at enjoying
HIFI music.
Introduction
Users manual
Contents list
AD10
3
4
5
6
USB ca b l e
PC
RCA ca b l e
Speaker cable
AMP
Left
Righ t
Speaker cable
Use USB cable to connect AD10 and PC (As picture c shows).
Connect AD10's Line Out to a headphone amplifier ora power amplifier or other device.
Maintain the volume of your headphone amplifier or power amplifier so no distortion and
will have much better listening experience.
Note: Please install the driver in the first time use; you can refer to"AD10 Driver and
Installation Guide"
7
US B
P C M
38 4K Hz
32B IT/38 4KHz DS D USB DAC
USB ca b l e
PC
OPT/ C O AX cab l e
DAC
( d )
9
10
11
8
2017 /8/22 12:12:23, AD10 Frequence Response For Line Out
2017/8/22 12:26:37, AD10 THD+N For Line Out@ A-W eighting
RMS Level (2017/8/22 12:12:23.057)
Bench Mode :Sweep
Bench Mode :Sweep
Measured 1
Measured 1
Measured 1
THD+N Ratio(2017/8/22 12:26:37.569)
FFT Spectrnm(2017/8/22 14:15:30.145)
Bench Mode:FFT
2017/8/22 14:15:30, AD10 FFT For Line Out@ 1 KHz
Bench Mode : FFT
Measured 1 2017/8/22 14:21:35, AD10 Noise For Line Out
FFT Spectrum (2017/8/22 1 4:2 1:35.243)
2 Digitalinterface application
Use USB cable to connect AD10 and PC, and connectthe AD10's COAXorOPT
OUT to a DAC. Then you can enjoy the wonderful music.
Note: COAX/OPT OUT can only output44. 1kHz-192kHz/ 16 Bit-24Bit PCM
signal.
3 Display
UseUSB cable to connect AD10 and PC, The display will show the format and
sample rate ofthe playing music.
0.72lb/ 326g
5.47 x 3.93 x 1.18inch
Shenzhen Aimpire Technology CO., LTD
703, Jinyucheng Building, Bantian Street, Longgang District, Shenzhen
http://www.aimpire.net
AD10 Driver Installation Download Link
AIMPIRE
/