Toro Steering Control Damper Kit, Z Master 300 Series Installation guide

Toro
Brand
Toro
Model
Steering Control Damper Kit, Z Master 300 Series
Type
Installation guide
The Toro Company – 2001
Printed in USA
All Rights Reserved
FORM NO. 3326–278
INSTALLATION
INSTRUCTIONS
Part No. 105–1666
Steering Control Damper Kit
Z–Master 300 Series
Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION QTY. USE
Lock nut
Damper
4
2
Install dampers
Remove Front Cover and Seat
1. Remove the front cover from the machine. There
are 4 bolts to be removed (Fig.1).
2. Remove the 2 bolts that hold the seat to the
frame (Fig.1).
1
6
m–5439
7
6
6
7
6
3
4
5
2
Figure 1
1. Front cover
2. Seat
3. Seat bolt
4. Washer
5. Spacer
6. Cover bolts
7. Nut
Installation Instructions
2
Remove Old Dampers and
Bracket
1. Disconnect the left and right control rods from
the motion control levers (Fig. 2).
2. Remove the old dampers from the bracket and
motion control levers (Fig. 2).
3. Remove the three bolts that hold the bracket to
the machine frame (Fig. 2).
Note: If there are springs attached to the
control system, remove and discard
them.
2
5
m–5440
1
6
4
8
7
3
7
Figure 2
1. Bracket
2. Control rods
3. Control lever
4. Damper
5. Bracket bolt
6. Bracket nut
7. Clevis pin
8. Cotter pin
Drill Bracket Holes
1. Bend the outside tabs on the bracket out. This
allows for holes to be drilled and dampers
installed (Fig. 3).
2. Drill 11/32 in. holes in the inside tabs. You may
have to do this at a slight angle (Fig. 3)
3
2
m–5442
4
3
2
1
4
Figure 3
1. Bracket
2. Outside tab, bent out
3. Inside tab
4. Drill 11/32 in. holes here
Install New Dampers
1. Install dampers, with rod end down, to the
bracket (Fig. 4).
2. Secure dampers to bracket with 4 locknuts
(Fig. 4). Torque locknuts to 21 ft–lbs.
Installation Instructions
3
4
6
5
2
3
3
7
m–5441
Figure 4
1. Damper
2. Bracket
3. Locknuts
4. Bracket bolt
5. Bracket nut
6. Rodend down
7. Control rods
3. Install bracket with new dampers to machine
(Fig. 4).
4. Connect the left and right rod ends to the motion
control levers.
5. Install the seat to the machine (Fig.1).
6. Install the front cover (Fig.1).
Check Operation
1. Drive machine and check the wheel tracking
with the control levers full forward.
2. If needed, refer to adjusting motion controls in
your operator manual.
Installation Instructions
4
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Toro Steering Control Damper Kit, Z Master 300 Series Installation guide

Toro
Brand
Toro
Model
Steering Control Damper Kit, Z Master 300 Series
Type
Installation guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents