Brief instructions
1
2 3 4
6 5
1. On/off button 4. Option key
2. Navigation key (up) 5. OK key
3. Display 6. Navigation key (down)
Programme Degree of soil, type of load
ECO 50°
• Normal soil
• Crockery and cutlery
AutoSense 45°-70°
• All
• Crockery, cutlery, pots and pans
ProZone 50°-65°
• Mixed soil
• Crockery, cutlery, pots and pans
Pro 70°
• Heavy soil
• Crockery, cutlery, pots and pans
30 Minutes 60°
• Fresh soil
• Crockery and cutlery
Glass 45°
• Normal or light soil
• Delicate crockery and glassware
Prewash
• All
Extra silent 50°
• Normal soil
• Crockery and cutlery
EN
OPTIONS OPERATING THE APPLIANCE
Starting programme How to delay the start of a programme
1. Press On/off.
2. Select programme from the programme list.
3. Set the applicable options.
4. Press OK to conrm and close the door.
1. Select a programme.
2. Press Option. The display shows the option list.
3. Select Delay start and press OK to conrm.
Select the number of hours desired for delay start.
4. Press OK.
5. Press Option until display shows
the selected programme
6. Press OK and close the door
Cancelling programme Cancelling Delay Start countdown
Press and hold Option until the display shows:
Stop washing?
• Select Resume and press OK to
continue the programme.
• Select Stop and press OK to cancel
the running programme.
Close the appliance door.
Press and hold Option for about 3 second
until the display shows: Stop Washing?
Select Stop and press OK to cancel delay start.
End of the programme Opening door during operation
1. When the programme is completed
the TimeBeam shows 0:00 and CLEAN.
2. Close the water tap.
• When you open the door, the running programme stops.
• When you close the door, the appliance continues from
the point of interruption.
• If the door stays open for longer than 30 seconds during
the drying phase, the running programme is cancelled.
How to set an option
1. Press Option.
2. Select an option
(XtraDry, TimeSaver, ExtraHigiene).
3. Press OK to conrm.
4. To go back to the programme list, press Option
until the display shows your selection.
How to set and save the
MyFavourite programme
1. Press and hold OK for about 3 seconds.
2. Press Option.
3. Select Settings and press OK.
4. Select MyFavourite and press OK.
5. Select programme from the programme list
and press OK.
6. The display shows Add option and Done.
• Select Done if you want to save a programme.
• Select Add if you want to add an option to
MyFavourite list.
7. Press OK to conrm.
DAILY USE CARE AND CLEANING
Cleaning lters
An incorrect position of the lters
may cause bad washing results
and damage to the appliance.
Cleaning spray arms
Do not remove spray arms. If
the spray arms are clogged
after cleaning, remove the soil
with a thin pointed object.
Internal cleaning
During cleaning, clean the
rubber gasket of the door.
Run long duration programmes
at least 2 times a month.
Use a specic cleaning product
for dishwasher every month.
External cleaning
Clean the appliance with a moist, soft
cloth. Do not use abrasive products,
abrasive cleaning pads or solvents.
1.
4.
2.
5.
3.
6.
1. Press the button. (A)
2. Insert detergent or tablet into
the compartment. (B)
3. If you want to choose a programme
with prewash phase, put a small
quantity of detergent on the inner
part of the appliance door.
4. Close the lid.
Filling rinse aid
container
Setting rinse aid level
Fill the rinse aid container before rst use and when the indicator is clear. (C)
1. Open the lid. (E)
2. Fill the container until marking
reaches MAX. (D)
3. Remove spilled rinse aid.
4. Close the lid.
Set the level of the rinse aid dispenser
according to the necessary quantity
of rinse aid.
Level 0, no rinse aid.
Level 6, maximum amount of rinse aid.
Using the detergent
Do not ll the detergent
container during rst use.
AB
CD
E
SAFETY INFORMATION TROUBLESHOOTING
Error codes
The appliance does
not ll with water.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the lter in the
inlet hose is not clogged.
• Make sure that the inlet hose
has no kinks or bends.
The appliance does
not drain the water.
• Make sure that the sink spigot is not clogged.
• Make sure that the lter in the
outlet hose is not clogged.
• Make sure that the interior lter
system is not clogged.
• Make sure that the drain hose
has no kinks or bends.
The anti-ood
device is on.
• Close the water tap and contact
an Authorised Service.
Water connection
Make sure not to cause damage to the water hoses.
• Before you connect the appliance to new pipes or pipes not used for a long
time, let the water ow until it is clean.
• The rst time you use the appliance, make sure that there is no leakage.
• The water inlet hose has a safety valve and a sheath with an inner mains
cable.
• Without electrical power, the water protection system is not active. In this
case there is a risk of ooding.
WARNING! Dangerous voltage.
If the water inlet hose is damaged, immediately close the water
tap and disconnect the mains plug from the mains socket. Contact
the Authorised Service Centre to replace the water inlet hose.
117883990-A-512016
-
1
-
2
-
3
-
4
Electrolux GA60PLVC Quick start guide
- Type
- Quick start guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Electrolux ESF6800ROW User manual
-
-
Electrolux ESF6800ROX User manual
-
-
Electrolux ESLP6815RA User manual
-
-
Electrolux ESLP8815RA User manual
-
-
-