Draper Ergo Plus VDE Torque Screwdriver Operating instructions

Brand: Draper

Model: Ergo Plus VDE Torque Screwdriver

Type: Operating instructions

DRAPER TOOLS LTD, HURSLEY ROAD, CHANDLER'S FORD, EASTLEIGH, HANTS. SO53 1YF. U.K. www.drapertools.com e-mail: [email protected]

Torque Screwdriver

Stock No.81763 Part No.965T/1

81762 965T/19

05/2015INSTRUCTIONS

TAKC140515

Locking Collar Scale

Handgrip

Main Scale

Quick Release Bit Holder

Examples of torque settings

Locking

Collar

Scale

0.02 N-m.

Main

Scale

0.3 N-m

2 N-m

2.3 N-m

Lock

Unlock

Increase

Reduce

1. Pull out the locking collar

for setting torque, turn Left

to increase torque, turn

right to reduce torque.

2. Torque setting is based on

main scale plus locking

collar scale. Adjust the

locking collar scale, which is

in increments of 0.02 N-m.

3. After adjusting torque

setting, push down locking

collar into “Lock” position.

EXAMPLE- 2.3 N-m

• View the main scale with the angle perpendicular to the handgrip.

• In order to extend the product service life, the torque setting should be adjusted to the minimum value if the product is

not to be operated for a long period.

Designed for applying the correct torque for engine casing screws, camshaft position sensors, ignition coils etc.

• Locking collar prevents accidental change of torque setting.

•

6% clockwise accuracy, complies with ISO:6789:2003.

• Range 1-5Nm.

• Only for clockwise torque tightening, cannot be used on reverse thread fixings.

Draper Ergo Plus VDE Torque Screwdriver Operating instructions

Draper Ergo Plus VDE Torque Screwdriver Operating instructions

Draper Ergo Plus VDE Torque Screwdriver Operating instructions

Other documents