Key Part No. Description Qty.
1 25617 Bottom, Filter Box 1
2 24183 Front, Filter Box 1
3 25618 Left Side, Filter Box 1
4 25619 Right Side, Filter Box 1
5 25620 Top Filter Box 1
6 25621 Bracket, Mounting 2
7 24187 Cover, Filter 1
8 25622 Cover, Conduit 1
9 83172 #10 Sheet Metal Screws 38
N/S 83343 #10 Sheet Metal Screws (Drill Point) 6
1
2
3
4
5
6
6
7
8
9
Figure 1. PARTS DIAGRAM
UNIVERSAL FILTER BOX
Instruction Sheet
C
O
M
P
A
N
Y
U
N
I
T
E
D
S
T
A
T
E
S
S
T
O
V
E
C
S
S
U
United States Stove Company
• 227 Industrial Park Road, P.O. Box 151 • South Pittsburg, TN 37380
Pt. #: 851744
UFB908UFB908
UFB908UFB908
UFB908
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Read all instructions carefully before starting the installation.
Assembly
1. Attach the left and right sides to the bottom with three(3) of the screws provided per
side.
2. Insert the front behind the bottom flange and attach with three(3) screws down each
side and five(5) across the bottom.
3. Set the top on the assembly and attach with four(4) screws on each side and two(2) in
the front.
4. Attach the mounting brackets to each side of the box assembly as shown with three(3)
screws per bracket. Don’t tighten the screws completey just yet.
Proceed to the following pages for attachment to your furnace.
Attaching the Filter Box to the Furnace
1. Place the Filter Box at the rear of the furnace and route the blower conduit through the
slots provided.
2. Attach the box to the furnace’s Cabinets sides using three(3) of the drill point screws
provided for each side.
3. Make final adjustments to the mounting brackets to insure a proper fit, then tighten
the six(6) screws retaining the brackets to the filter box.
4. After Conduit placement has been determined, install the Conduit Cover over the re-
maining conduit slots using two(2) of the screws provided.
5. Install a standard 16 x 20 filter (not included) in the filter slot and cap it with the cover
and three(3) screws as shown.
IF OPERATIING THE FURNACE IN A POWER OUTAGE, YOU MUST REMOVE THE
FILTER. ONCE POWER HAS BEEN RESTORED, RE-INSTALL THE FILTER AND COVER
FOR NORMAL OPERATION
Use three(3) Drill point Screws provided
Make final adjustments, then tighten
Conduit Cover
Slots for Conduit
-
1
-
2
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
Other documents
-
Harman Stove Company SF 3500A User manual
-
-
United States Stove 1600 User manual
-
-
Breckwell SF747 User manual
-
Honeywell F300E User manual
-
CLEAN BURN CB-1750 User manual
-
Meyer 4000 User manual
-
-
GE ZGU365DWBWG User manual
