T-8 Vapor Tight Light
#6219 Fluorescent T-8 Light
www.
Home
Selects
.com
INSTALLATION INSTRUCTIONS:
Assembly and safety instructions
CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE
ANY QUESTIONS PRIOR TO INSTALLATION
Install the T-8 uorescent tubes
Pinch the mounting clips to remove
and replace the light frame
Thank you for purchasing this V
apor Tight Light. For more information please e-mail us at
[email protected]
DANGER: Before installation, turn off the main
power at the circuit breaker.
WARNING: Installation must be performed by a
qualified licensed electrician.
CAUTION: To prevent electric shock, do not insert
any objects through openings.
3
Assembly of light fixture
Assemble the light fixture using the clips.
Make sure the acrylic diffuser is seated correctly for a tight fit.
Install the T-8 fluorescent tubes carefully (tubes not included).
4
Mounting the fixture
Mount the metal clips to the surface where light is to be placed.
The mounting clips should be spaced 31” apart
Snap the fixture into the clips making sure it is secure
Never drill through fixture to mount. This will compromise the
water tight feature and could cause damage to the fixture.
1
Assembly of the light fixture
Remove the metal fixture pan from the base housing
by pinching together the retainer clips.
Install the retainer clips by snapping them into the
base housing.
Accessories included
(Mounting hole locations)
50”
3.5”
31”
2
Connecting the wires
Connect the black supply wire to the black fixture wire.
Connect the white supply wire to the white fixture wire.
Connect the ground supply wire to the ground fixture wire.
BLACK Supply Wire
BLACK Fixture Wire
WHITE Fixture Wire
WHITE Supply Wire
GROUND Supply Wire
GROUND Fixture Wire
Wiring diagram
Install the cover making sure the gasket
is in place
Install the diuser retainer clips
Install the metal plate mounting clips