2. Hagerco
  3. 1756 - 185 Degree Door Viewer

Hagerco 1756 - 185 Degree Door Viewer Installation guide

  • Hello! I am an AI chatbot trained to assist you with the Hagerco 1756 - 185 Degree Door Viewer Installation guide. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
1756 - 185˚ DOOR VIEWER
INSTALLATION INSTRUCTIONS
I-TA01241
Rev -, Rev Date: 11/18/2019 Page 1 of 1
1. Determine mounng posion on door. Recommended: height of 60” [152 cm] installed in center
of the door for standard mount or height of 43” [109 cm] installed in center of the door for ADA
accessible door viewer (See Figure 1).
2. Mark the desired posion on the door for drilling.
3. Center punch and drill 9/16” pilot hole.
4. Insert the viewing side of viewer into the hole from the inside of the door. Insert the lens side of
viewer into the hole from the outside of the door. (See Figure 2)
5. Tighten by placing a at head screw driver into the slot on the viewing side of the door viewer.
Tighten the lens side while holding the viewing side staonary (See Figure 3).
6. Tighten unl viewer is secured.
TOOLS REQUIRED
FIGURE 1
FIGURE 2
FIGURE 3
/