Noble House 305434 Operating instructions

Assembly Instructions

Caution: You must read this before you proceed

Chair

Parts List

Label Picture Description QTY

A

Backrest Panel 1

B

Seat Panel 1

C

First Leg Panel 1

D

Second Leg Panel 1

Hardware

Label Picture Description QTY

①

Screw (M6x80mm) 7

②

Allen Key 1

Assembly Preparation

Before Beginning Assembly:

Assembly Steps

Overview

This Chair has multiple parts and may require up to 30 minutes to assemble. To give you an

overview of the Chair parts, the above picture is to help you put the various parts into perspective.

Please read through the instructions below to familiarise yourself with the parts and steps before

assembly.

Step 1

Unpack and place all parts on a clean, non-marring surface.

Backrest Panel (A)

Second Leg Panel (D)

First Leg Panel (C)

Seat Panel (B)

Step 2

2.1) Position First Leg Panel(C) and Backrest Panel(A) to Seat Panel(B).

2.2) Attach Second Leg Panel(D) to Backrest Panel(A), and Seat Panel(B) using Screws(①) with

Allen Key(②).

Do not fully tighten the Screws.

Note: Be sure to position the Seat Panel correctly as indicated by the label "Front"

Step 3

D



2.1

B

C

A

2

1

2



C



D



A



B

F

r

o

F

r

o

F

r

o

2.2

With assistance from an adult partner, turn the Chair Frame over onto the other side.

Attach First Leg Panel(C) to Backrest Panel(A), and Seat Panel(B) using Screws(①) with Allen

Key(②).

Do not fully tighten the Screws.

Step 4

Place the Chair on a LEVEL SURFACE to see if it wobbles.

If it wobbles, lift the Chair to some 30cm to 50cm high from the ground. Keep your feet and toes

well away from the drop zone.

Drop the Chair freely and vertically with the four legs, hitting the ground, at the same time.

This Drop Test will help to ensure that all the Screws and gaps reach full alignment status.

Test again for evenness on a LEVEL SURFACE.

If no wobbles are found, proceed to tighten all the Screws.

When tightening the Screws, tighten sequentially.

DO NOT tighten any Screw fully and then move on towards the next one.

This could cause the frame to warp.

If there are still wobbles, loosen the Screws and execute this same drop test.

Step 5

Your Chair is ready to use.

This Chair can only be used on a flat, level surface



EXTENSION TABLE

CAUTION: You must read this before you proceed

CAUTION: This Table is NOT a TOY.

Keep your child / children at bay in the process of assembly.

For turning the Table and to prevent damage to the Table, 02 persons may be needed

to execute this action.

Noble House Home Funishings LLC 1

Label Picture Description Qty

A

Table Top

1

B

Expansion

Board of Table

Top

1

C

Leg 4

No. Picture Description Qty

①

Allen Key 2

②

Bolt

(M8*55mm)

9

③

Washer

9

④

Screw

(M7*60mm)

3

Noble House Home Funishings LLC 2

Before Beginning Assembly:

This Table has multiple parts and may require up to some 30 minutes to assemble. To

give you an overview of the Table, the above picture to assemble to help you put the

various parts into perspective. Please read through the instructions here below to

familiarise the parts and steps before assembly.

OVERVIEW

Table Top (A)

Leg (C)

Expansion

Board of Table

Top (B)

FRONT FACING

Noble House Home Funishings LLC 3

Step 1

Put the Expansion Board of Table Top (B) into the Table Top (A)

Then, secure Expansion Board of Table Top (B) with Table Top (A) by using 2 Screws

(④)+ Allen Key (①) as designated points as picture above.

Unpack and place all parts on a clean non-marring surface.

With assistance from your adult partner, Carefully place the Table Top (A) with

Expansion Board of Table Top (B) face down.

Step 2

Noble House Home Funishings LLC 4

Step 3

Attach one of Legs (C) to Table Top (A) by using 2 Bolts (②), 2 Washers (③) and Allen

Key (①).

Repeat the same step for 3 remaining legs (C).

With assistance of your adult partner, carefully stand the Table up.

EXERT pressure, floorwards, onto the Table.

This pressure will help the Legs and Table Top reach alignment at all joints.

Check for wobbles.

In a sequential manner, gradually tighten all Bolts until evenly secured.

Inspect the Table and make sure all parts are adequately connected.

Your Table is ready for use.

This Table can only be used on a flat, level surface.

Step 4

Noble House Home Funishings LLC 5

Gently pull the Table Top (A) outwards to open and stop when it could see the extension

board frame support.

Caution: Do not Lean on or apply pressure to the table when it is pulled open. This

could cause damage to the product.

2.1) Turn the Expansion Board of Table Top (B), located inside of the table as shown

above.

2.2) Push the Table Top (A) inwards until the Top Table (A) fits in the Expansion Board

of Table Top (B).

Caution: Keep hands away from the Table Top (A) and Expansion Board of Table

Top (B) when pushing the Table Top to avoid pinching hazards.

If you can not push the Table Top (A) inwards, Just slightly shake the Table Top

(A).

Step 1

Step 2

Extension Steps: To Extend the Table

2.2

2.1

Noble House Home Funishings LLC 6

Step 3

Lock the Metal Fastener under the table to lock the Expansion Board of Table Top (B)

into place.

Your Table is extended and is now ready for use.

Unlock the Metal Fastener before retracting.

Step 1

Extension Steps: To Retract the Table

Noble House Home Funishings LLC 7

Step 2

2.1) Gently pull theTop Table (A) outwards to open and stop when it could see the

extension board frame support.

2.2) Turn the Expansion Board of Table Top, located inside of the table as shown

above.

Caution: Do not Lean on or apply pressure to the table when it is pulled open. This

could cause damage to the product.

Step 3

Push the Table Top (A) inwards until two wings of Table Top (A) align.

Caution: Keep hands away from the Table Top (A) and Expansion Board of Table

Top (B) when pushing the Table Top (A) to avoid pinching hazards.

If you can not push the Table Top (A) inwards, Just slightly shake the Table Top

(A).

Step 4

Lock the Metal Fastener under the table to lock the Expansion Board of Table Top (B)

into place.

Your Table is extended and is now ready for use.

2.1

2.2

Noble House Home Funishings LLC 8

Noble House Home Funishings LLC 9

Noble House 305434 Operating instructions

This manual is also suitable for

Noble House 305434 Operating instructions

Related papers