of comprehensive guidelines and establish permitted levels of
RF energy for the general population. The guidelines are based
on standards that were developed by independent scientic
organizations through periodic and thorough evaluation of
scientic studies. These guidelines include a substantial safety
margin designed to ensure the safety of all persons, regardless of
age and health.
The exposure standard for phones employs a unit of
measurement known as the Specic Absorption Rate, or SAR.
The SAR limit set by public authorities such as the Federal
Communications Commission of the US Government (FCC), or by
Innovation, Science and Economic Development Canada (ISED),
is 1.6 W/kg averaged over 1 gram of body tissue, and Limbs is 4.0
W/Kg averaged over 10 grams. Tests for SAR are conducted using
standard operating positions with the device transmitting at its
highest certied power level in all tested frequency bands.
This device is complied with SAR for general population /
uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and had
been tested in accordance with the measurement methods and
procedures specied in IEEE1528.
Although the SAR is determined at the highest certied power
level, the actual SAR level of the device while operating can be
well below the maximum value.
This is because the device is designed to operate at multiple
power levels so as to use only the power required to reach the
network. In general, the closer you are to a wireless base station
antenna, the lower the power output of the device.
Before a device model is available for sale to the public,
compliance with national regulations and standards must be
shown.
The highest SAR value for this model device when tested is 0.54
W/Kg for use close to the body, and 0.67 W/Kg for Limbs.