Instructions for Assembly of Lighthouse Fountain
For additional help please visit our website at www.angelodecor.com
Insert screw (provided) into top position top onto spill bowl attach nut (provided)
tighten nut firmly position top together as shown Set pump to 3/4 strength
Important Information about Solar Powered Lights:
Please dispose of used battery properly.
The unit will turn on automatically at night. To activate this feature,
use the "on/off switch" located on the battery compartment cover.
(pictured at right) This can also be used to turn the unit off when
not in use, helping extend battery life.
The light is powered by a battery, included with this unit. No wiring
is required. You can replace the battery using a rechargeable "AA"
style battery only.
Carefully unpack the unit placing parts securely in your work area. Feed pump cord through pipe in bowl, run through pedestal,
and pull out cord slack. Fit cord in groove at bottom. Line up twist and lock and attach.
Attach tubing securely to pump. Make sure
tubing length allows pump to sit firmly at bottom
of cavity without bending, as this may reduce
water flow. (some trim may be required) Line up
twist and lock and turn into place. Top should sit
firmly, lined up as shown.
Note the location of the solar panels. The unit
should be placed in an area with clear access to
natural light. An initial charge of at least 8 hours
of sunlight is required before first use.
/
