2. TONNEAU COVER
  3. 59312
59312

TONNEAU COVER 59312 Installation guide

  • I've reviewed the provided installation guide for the soft folding tonneau cover, and I'm ready to answer your questions. This guide includes a detailed parts list and instructions how to install the cover, as well as seal it correctly and fold it. Feel free to ask me anything you need clarification on.
  • What should I do before installing the cover?
    What to do if truck bed rail is lower than sides?
    How to fully fold the cover?
Page 1/7
Bed cover*1
Seal strip 118(in)
Light
Front clamps
Triangle screw
T-bar
ITEM DESCRIPTION QTY.
1
2
3
4
5
1
4
4
4
1
12
3
45
6
INSTALLATION
GUIDE
SOFT FOLDING TONNEAU COVER
PARTS LIST
Page 2/7
1. l Clean truck bed thoroughly before installaon.
l Sck the supplied front seal strip on the front bed rail by aligning with the
outer edge.
l Install the provided LED
lamps according to the
actual situaon of the
truck bed.
2. l Slide the two aluminum blocks at the front end to the most suitable
posion.
l IF THE TRUCK'S FRONT BED RAIL IS LOWER THAN THE
SIDES, USE THE PROVIDED WEATHER SEAL STRIPS. GAPS
ON THE FRONT BED AND TAILGATE WILL CAUSE NOISE AND
FLAPPING ISSUES WHILE THE VEHICLE IS IN MOTION!
3
Page 3/7
4. l Slide the front clamp to the best posio, clamp the interface under the
metal bed rail, and then use the Triangle screw to rotate into the metal
rod to fix the enre clamp
l Clamp the T-bar on the aluminum slider of the first fold, use Front clamps
and Triangle screw to install it on the T-bar to complete the first fold.
3.
ⅠⅡ
Ⅲ
5.
6.
Page 4/7
l Open the bungee cord at the front end,fully unfold cover towards the
tailgate and ensure cover ailgns on all sides
7.
8.
Page 5/7
l Adjust the connecon posion of the rear clamp and T-bar according
to the actual situaon, open the cover and place it on the lathe, and push
the rear clamp vercally to fix it to the rails on both sides of the lathe.
All clamps must be
firmly in contact
with the lip of the
metal bed rail to
ensure a firm cover.
Finally, close the
tailgate to complete
the installaon.
l Aer rear clamps have been latched securely, close/lock tailgate and cover
cannot be opened from the outside
FINISH THE INSTALLATION
NOTE: COVER MAY NOT COMPLETELY COVER TO THE
OUTSIDE EDGE OF THE BED RAILS DUE TO SLIGHT
DIFFERENCE IN TRUCK BED SHAPE FOR DIFFERENT
YEAR MODELS
Page6/7
When it is necessary to completely foldthe cover, place the rear clamps correctly
clamping rubber block, and then fold it.
9.
Page 7/7
1 2 3
J-shaped aluminum*6
Screw base*12
Screws, washers*12
Slide the screw base into
the system rail
Put the gaskets in order and ghten
the screws
Fix the J-shaped aluminum
according to the posion of
the clamps on the cover
Aach Front Clamps
on to J-shaped aluminum
Aach rear Clamps
on to J-shaped aluminum
SPECIAL INSTRUCTIONS FOR ALTERNATIVE BRACKETS
SUPPLEMENT TO INSTALLATION INSTRUCTIONS (Only
for models with system track)
/