Sweex ST011 Datasheet

Brand: Sweex

Model: ST011

Category: HDD/SSD enclosures

Type: Datasheet

Sweex ST011 is an external storage solution that allows you to quickly and easily connect an additional 3.5" hard disk to your PC or notebook via USB 2.0. It features a metal casing, supports Windows 98SE, 2000, and XP, and has a maximum data speed of 480 MB/s. The package includes a USB cable, external power supply, CD-ROM, support base, screwdriver, and screws. With its Plug and Play and bus-powered features, setup is easy and convenient.

English version

ST011 Sweex 3.5” External Storage Solution USB 2.0

ST011UK Sweex 3.5” External Storage Solution USB 2.0

Introduction

First of all, many thanks for purchasing the Sweex 3.5” External Storage Solution USB 2.0. By means of this external casing you can quickly

and easily connect an additional 3.5" hard disk to your PC or notebook. The external casing features a USB 2.0 connection.

To ensure this product operates correctly, we advise you to carefully read this manual first. If despite this manual you still experience problems

during installation or operation of this product, go to www.sweex.com and look under the heading service & support.

Contents of the box

Prior to installation, check if all required parts are present. The following parts must be present in the box:

• Sweex external 3.5” casing

• USB cable

• External power supply

• CD-ROM

• Support base

• Screwdriver

• 8 screws

If one of the above parts is missing, please contact the supplier.

Specifications

• Metal casing

• Suitable for: 3.5” IDE/ATA

• Interface: USB 2.0

• Inclusive of USB cable

• Inclusive of USB feeder cable

• Plug and Play

• Bus-powered

• External power supply of 100-240V

• Maximum data speed USB 2.0: 480 MB

• Supports: Windows 98SE, 2000, XP

• Dimensions: 110 x 195 x 30 mm (W x L x H)

• Weight: 232 grams

S W E E X . C O M

English version

Installation

Remove the metal top and bottom of the external casing. In the casing you can now see both the IDE cable and the power supply connection

for the 3.5"IDE hard disk. Carefully slide the IDE cable connector onto the hard disk. Note that the cable is properly connected; do not force

anything. Connect the power supply cable at the same time.

Screw four screws (included) tight into the bottom so that the hard disk is properly secured. See the illustration below.

Re-attach the metal top and bottom of the external casing and screw these tight with four screws (included).

Note!

Depending on the number of USB devices connected, the USB port of the computer may supply insufficient power. In that case, you can use an

optional external power supply adaptor. This adapter must provide five volts (DC voltage) / two amperes.

Once connected, Windows will prompt that new hardware has been found. After a few seconds this notification will be replaced with the note

that the hardware is ready to be used. Windows will now display an additional drive letter for the 3.5" unit.

Warranty

All articles supplied under the name Sweex have a warranty of three years. We do not provide support or warranty on supplied software,

rechargeable batteries and batteries. Warranty work is only handled via the dealer where the article was purchased.

All brand names and the associated rights mentioned in this manual are and remain the property the rightful owner.

Sweex ST011 Datasheet

Brand: Sweex

Model: ST011

Category: HDD/SSD enclosures

Type: Datasheet

Download PDF

report

Sweex ST011 Datasheet

Sweex ST011 Datasheet

Related papers