Please note all images are generic representations. Individual brackets and hardware will vary depending on the specific product.
Step 1
Turn the projector upside down on a soft, flat surface.
Remove foot levelers and place the bracket on the projector.
Align the bracket holes with the projector mounting holes.
Step 2
Raise the projector (with mounting bracket attached) and hook the
projector bracket over the hinge pins (A).
Make sure the bracket is resting on the Base Box (B) before letting go
of the projector.
Step 3
Insert and tighten supplied tilt adjustment knurl knob screws, two (2)
per side.
Follow the PDS Installation instructions for further adjustment instruc-
tions to complete the installation.
A
B
www.mounts.com | North America 800.368.9700 | International +1-714-632-7100 | Europe +44 (0) 24 7664 4105
1321 S. State College Blvd., Fullerton, CA 92831 USA
Warranty, Garantie, Garantía, Garanzia, Garantie, Waarborg: http://www.mounts.com/warranty
9530-000-000-00
Installation Guide
Installationsanleitung, Guía de Instalacíon, Guida de Installazione, Guide d’Installation, Installatie gids
PDS DEDICATED BRACKET
/