MK Diamond Products BX-4 Operating instructions

MK BX-4 Stand Setup Instruction

Part No. 162771

Instructions:

1. Open stand and set it on a flat & leveled surface.

2. Place saw’s footing within the 4 corner brackets on the stand as shown in figure.

3. Loose Knob (1) and move Hold Down Bracket (2) over the Left Rail (3).

4. Place the hook portion of the Bracket (2) over top the Left Rail and lay it on top

of the rail..

5. Tighten up the Knob (1) to secure saw in place..

Rel. 7/31/2007

Corner Bracket

This manual is also suitable for