5019 100 75025
AKR 690-691-692-693
c
c
a
a
b
b
a
1.
Control panel
2.
Grease filters (1 or 2 parts)
3.
Lighting unit
4.
Grease filter support
REMOVING AND RENEWING OR
CLEANING THE GREASE FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Pull the handle downwards to remove the
dirty grease filter.
3.
After cleaning the grease filter repeat the
above steps in reverse to reassemble,
making sure the entire extraction surface is
covered.
RENEWING BULBS
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the grease filter support
(sequence a-b).
3.
Remove the burnt-out bulb and insert a new one.
Use only 40W max E14 bulbs.
4.
Remount the grease filter support.
MOUNTING OR RENEWING THE
CARBON FILTER:
1.
Unplug the appliance or switch off the mains
power supply.
2.
Remove the grease filter support
(sequence a-b).
3.
If the carbon filters are already mounted
(one or two filters, depending on model,
covering the motor protection grilles) and
need renewing, turn the central knob (c)
anticlockwise until the filters are released.
4.
If the filters are not mounted, fit them to cover
the motor protection grille (for two protection
grilles - two carbon filters, for one grille - one
carbon filter). Turn the central filter knob (c)
clockwise.
5.
Remount the grease filter support.
CONTROL PANEL
A.
Light switch.
B.
Speed selector.
2
3
3
1
4
O I
O123
small amount of
steam and fumes
medium amount
of steam and fumes
AB
GB
F
PRODUCT DESCRIPTION SHEET
large amount
of steam and
vapour
