Changing the battery
The Apresys EZ600 Laser Rangefinder uses 3V CR2 (x1) battery.
1. Open the battery compartment cover.
2. Replace the old 3V CR2 Lithium battery with a new one (ensure that the negative terminal of the battery
is inserted first).
3. Close the battery compartment cover.
NOTE: It is recommended that the battery be replaced at least once every 12 months.
Measurement
1. Install a battery in the battery compartment (See “Changing the battery”)
2. Turn on the power by briefly pressing the “ON” button (confirm that the display is on by looking through
the eyepiece).
3. Adjust the diopter to obtain a clear display through the eyepiece.
4. Position the target in the center of the aiming reticule.
4.1 For Single measurement mode, press and release the “ON” button. The result will display momen-
tarily.
4.2 For Scan measurement mode, press and hold the “ON” button while slowly moving the rangefinder
from one target to next. The results will refresh as each new data is obtained.