Graco PD202866AL DUODINNER Owner's manual

DuoDiner

TM

Graco PD202866A 4 12

Highchair Infant/Toddler Feeding Booster Seat

(Infant seat attached to chair)

This product can be used in the following modes:

Failure to follow these warnings and the assembly instructions could result

in serious injury or death.

sPLEASE SAVE OWNER’S MANUAL FOR FUTURE USE.

sFOR YOUR CHILD’S SAFETY, read the labels and the

owner’s manual before using product.

sADULT ASSEMBLY REQUIRED.

sNEVER LEAVE CHILD UNATTENDED. Always keep

your child in view.

sNEVER allow a child to push away from table.

sPREVENT SERIOUS INJURY OR DEATH FROM

SLIDING OUT, FALLS, OR TIPPING OVER. Always use

seat belt. Secure your child at all times with the restraint

system provided, either in the reclining or upright position.

The tray is not designed to hold your child in the product.

It is recommended that the product be used in the upright

position only by children capable of sitting upright

unassisted.

sTHIS PRODUCT IS DESIGNED AS A highchair for use

with child up to 3 years of age or as an infant feeding

booster seat for use with a child up to 6 years of age and

up to 60 lbs (27.3kg).

sDO NOT FORCE TRAY against child. Use only the three

adjustment positions. Be sure both adjustment fingers are

engaged in armrest slots.

sSTRANGULATION HAZARD Do not place product in

any location where there are cords, such as window blind

cords, drapes, phone cords, etc.

sFOLLOW ASSEMBLY INSTRUCTIONS CAREFULLY. If

you experience any difficulties, please contact the

Customer Service Department.

sPREVENT SERIOUS INJURY OR DEATH. Do not use in

motor vehicles.

sDO NOT ADJUST the height or recline of product with

your child in it.

s ALWAYS USE booster straps to attach infant/toddler

feeding booster seat to any chair. Always ensure straps are

pulled tight.

sIF INFANT/TODDLER FEEDING BOOSTER SEAT

CANNOT be securely and safely attached to the adult

chair, do not use infant/toddler feeding booster seat with

that chair.

sTHIS INFANT/TODDLER FEEDING BOOSTER SEAT is

designed to be used by a child up to 60lbs (27.3kg).

sUSE ONLY DuoDinerTM highchair accessories with this

product.

sUNTIL CHILD IS ABLE to get in and out of the infant

feeding booster seat without help (about 2 1/2 years old),

the child should be secured in the infant/toddler feeding

booster seat at all times by the restraining system. The tray

is not designed to hold the child in the chair.

!,,-/$%,3

This model may not include some features shown below. Check that

you have all the parts for this model BEFORE assembling your product.

If any parts are missing, call Customer Service.

0ARTSLIST

No tools required.

2X

ACCESSORIES ON CERTAIN MODELS

1

To set up, squeeze buttons on either side of highchair

legs and push front legs forward as shown.

Assembling Highchair 

2

Attach legrest by snapping it onto center bar as

shown.

3

Rotate legrest down to secure.

Be sure the bar is securely attached into the legrest as

shown.

4

6

5

Rotate footrest down to secure.

You may need to adjust position of footrest once your

child is seated in chair.

Insert footrest into slots as shown.

1

3

2

While pulling up on handle on seat back, insert

seat back, into the slots on the seat base as shown.

Release handle on back and allow rods on side of seat

back to insert into one of the sets of holes in the seat

base.

Rods should be inserted into same slots on each side of

the seat.

Flip seat over.

Insert pins into seat base and seat back as shown.

2X

Infant/Toddler Feeding Booster Seat Assembly

Attach seat pad to infant/toddler feeding booster seat

as shown. Pull waist straps through openings in seat

pad.

Seat Pad

2

Insert webbing through opening in seat back as

shown.

1

3Pull shoulder straps and crotch strap through

openings in seat pad.

4

Wrap seat pad over the top of the infant/toddler

feeding booster seat.

5

6

Make sure recline handle is sticking out the hole in the

seat pad.

Secure seat pad with hooks as shown.

8

7

Secure seat pad with hooks at the front of seat as

shown.

SNAP!

Fasten snaps as shown.

1

3

2

Pull waist straps through openings in body support.

Body Support

Pull shoulder straps through openings in body

support.

Place body support on top of the seat pad.

1

3

2

Place infant/toddler feeding booster seat on highchair.

NOTE: Be sure that guides on sides of infant/toddler feeding

booster seat go into channels on highchair arms as shown.

Make sure the clear compartment holding the straps under

the seat is closed before attaching seat to highchair frame.

Check infant/toddler feeding booster seat is latched into place by pulling up on it.

To remove infant/toddler feeding booster seat,

push in buttons on side of seat and pull up.

Attaching Infant/Toddler Feeding Booster Seat to Highchair

WARNING: DO NOT remove infant/toddler feeding booster seat

with the child in it.

SNAP!

1To attach tray, squeeze both side handles on bottom

of tray and place on highchair or squeeze button and

slide on.

Tray

To remove tray, squeeze both side handles on bottom

of tray and lift up or squeeze button and slide off.

2

OR

SNAP!

1

2To remove pull up on the back of the tray.

Tray Cover

Attach tray cover by pushing it down on the tray.

Dishwasher safe.

(ARNESS3YSTEM

WARNING

&ALLING(AZARD

Always use the seat belt.

0OINT(ARNESS 0OINT"UCKLE

2

4

3

To convert to 3-pt

harness.

Use slide adjuster at

waist for further

adjustment.

Use slide adjuster at

shoulder and waist for

tighter adjustment.

5

1 6

7

8

9

10

11 When changing harness strap slots, MAKE SURE

harness straps are going through same slots in seat

pad and seat back.

The harness straps must go into slot that is even with

or slightly above the shoulders. Avoid twisting straps.

1

2

To adjust height, squeeze buttons on the back of both

legs and lower or raise seat.

WARNING: DO NOT adjust the height of

the product with the child in it.

!DJUSTING(EIGHT

There are 5 height positions.

1

2

Squeeze handle on back of seat and push down or

pull up to adjust.

WARNING: DO NOT adjust the seat

recline with the child in it.

Recline

There are 3 recline positions.

1

2

Attaching infant/toddler feeding booster seat to chair

Turn infant/toddler feeding booster seat over.

Open clear compartment on bottom of infant feeding

booster seat.

3

Tabs

Insert two rear straps into slots in infant/toddler

feeding booster seat as shown.

MAKE SURE belt is placed over top of plastic tabs on

bottom of seat as shown.

Pull straps out of compartment as shown.

Place infant/toddler feeding booster seat on a chair

with no armrests and that has a back, ensuring that

the straps are hanging freely.

Make sure that there are no extra seatpads or

cushions on the chair that you are using with the

infant/toddler feeding booster seat.

Wrap top straps around back of chair and secure clip.

Tighten by pulling on the adjustment strap.

4

5

6

Wrap bottom straps around base of chair and secure

clip under the chair. Tighten by pulling on the loose

strap.

CHECK to make sure infant/toddler feeding booster

seat is securely attached by moving from side to side.

SNAP!

Page is loading ...

Graco PD202866AL DUODINNER Owner's manual

Graco PD202866AL DUODINNER Owner's manual

Related papers

Other documents