2. Computers & electronics
  3. Telecom & navigation
  4. Mobile phones
  5. Car kits
  6. Borum Industrial
  7. 1187T

Borum Industrial 1187T, 2036T, 2038T, BHSP20T, BHSP30T, BPROSP50T Operating instructions

  • Hello, I've read the operating instructions for the Hydraulic Workshop Press. This document provides important guidance on using the 2-speed pump, preventing over-extension of the ram piston, and proper mandrel selection. It also covers regular maintenance checks, such as oil leaks and cleanliness. I'm ready to answer any questions you might have about the workshop press based on this document.
  • What is the purpose of the fast mode on the hydraulic pump?
    When should I switch to slow mode?
    What happens if the hydraulic ram piston is over extended?
    How can I fix a loose retaining plate?
    What should I do if I notice oil leaks?
IMPORTANT
OPERATING
INSTRUCTIONS
Other hints...
Oil leaks. All hydraulic parts and lines should be regularly checked as a very small leak can turn into a very big mess. Loose fittings
should be tightened and wiped clean of spilled oil. Keeping a press clean will help you locate any new leaks that might develop.
Oil level. If necessary, top it off. To determine the type of oil you should use, always refer to the Owners Manual.
Loose bolts. Some jobs cause vibration and shock that can loosen bolts around the tooling area.
Press ram. It should always be clean and moist, but not dripping oil. Always retract after use.
Cleanliness. Check to be sure the work area is clean. This helps to ensure a safe work environment and prevent accidents.
HYDRAULIC
WORKSHOP PRESS
www.tqbbrands.com.au
The 2-Speed hydraulic pump uses a slow-fast pump system
that in Fast mode, is used only to advance the ram to the load
surface. Once the ram takes up the load the slow-fast knob
must be turned to Slow mode to provide the high pressure
delivery of oil required for efficient pressing application.
2-Speed Hydraulic Pump
The loosening of the “Hydraulic Ram Piston Retaining Plate” becomes
apparent ‘only’ when the hydraulic ram piston has been over extended.
OVER EXTENDING THE PISTON RAM results in a loosening of the
retaining plate that secures the ram cylinder in the ram. This is rectified
by knocking the RETAINING PLATE back into the locked position(see
image) using a light hammer and a pin punch. Insert the pin punch into
the hole at the bottom of the ram cylinder and knock the RETAINING
PLATE back into the locked position.
Note: The cross beam working table (BED) should always be lifted to
the ram and will prevent loosening of the “Hydraulic Ram Piston Retain-
ing Plate”.
Over Extending the Hydraulic Ram Piston
Borum Hydraulic Press Adaptor Kits include 8 different sized
pins (mandrels) ranging from 2,000kg to 20,000kg capacity, a
pin holder, a storage shelf along with a mounting kit, and a pin
plate with the weight capacity shown for each pin. This very
handy set of eight steel mandrels, adaptor and press plate
expands the safe uses of your workshop press for a wider
range of applications involving different sized work pieces.
Simply select your mandrel according to the size of the work
piece load bearing surface.
It’s Safer to use a correct size Mandrel
/