Ei Electronics Ei167RC User manual
- Category
- Smoke detectors
- Type
- User manual
Ei Electronics Ei167RC is a mains-powered, 230V AC remote siren with a built-in rechargeable battery, designed to be interconnected with Ei smoke or heat alarms. It provides a loud alarm when triggered by a connected smoke or heat alarm, alerting you to a fire emergency in areas where a smoke alarm may not be suitable, such as kitchens or corridors.
Ei Electronics Ei167RC is a mains-powered, 230V AC remote siren with a built-in rechargeable battery, designed to be interconnected with Ei smoke or heat alarms. It provides a loud alarm when triggered by a connected smoke or heat alarm, alerting you to a fire emergency in areas where a smoke alarm may not be suitable, such as kitchens or corridors.
The Remote Siren Ei167RC is designed to be interconnected to
an Ei Smoke or Heat Alarm (230V a.c. only) so that when fire is
sensed the Siren will sound. It is very similar to an Ei161RC
Smoke Alarm except that it contains no smoke sensor so it will not
respond to fire itself but relies on a signal on the interconnect wire
to make it sound. It is ideal for installation in areas such as
kitchens or corridors where an alarm needs to be given but where
a Smoke Alarm would be prone to nuisance alarms or excessive
contamination.
The Remote Siren Ei167RC must only be connected to the follow-
ing Ei Smoke Alarm and/or Heat Alarms: Ei141/144/146/151/154
/156/161RC/164RC/166RC. A maximum of 12 Units including the
Remote Siren can be interconnected. Do not connect to any other
type of Ei Smoke Alarm or to any other model produced by
another manufacturer. Doing this may damage the units and could
result in a shock or fire hazard.
The installation of an Ei167RC Remote Siren is exactly the same
as that for an Ei161RC Smoke Alarm (see details in the enclosed
Ei161RC instruction leaflet). Obviously, as the Ei167RC contains
no smoke sensor it need not be located at ceiling height and the
other siting restrictions applicable to the smoke sensor in the
Ei161RC Smoke Alarm need not be followed.
After installation and regularly thereafter check:
(1) The green power light is on showing the AC mains is
connected.
(2) Press the test button on the remote siren - the siren should
sound within 10 seconds and also the Smoke Alarm(s)
interconnected to it should sound. The red LED should flash once
a second.
(3) Press the test button on an interconnected Smoke Alarm - the
Remote Siren should sound within 10 seconds.
Your Remote Alarm should be checked regularly as above when
you are checking your Smoke Alarm.
The rechargeable battery in the Remote Alarm should be checked
in the same way as for the Ei161RC Smoke Alarm.
AICO LTD
Oswestry,
Shropshire SY10 8NN,
United Kingdom.
www.aico.co.uk
Ei Electronics
Shannon,
Co.Clare,
Ireland.
www.eielectronics.com
Checking the Remote Siren
230V a.c. REMOTE SIREN
(with built-in rechargeable battery)
Model
Ei167RC
P/N A14443 Rev1
The Remote Siren Ei167RC is designed to be interconnected to
an Ei Smoke or Heat Alarm (230V a.c. only) so that when fire is
sensed the Siren will sound. It is very similar to an Ei161RC
Smoke Alarm except that it contains no smoke sensor so it will not
respond to fire itself but relies on a signal on the interconnect wire
to make it sound. It is ideal for installation in areas such as
kitchens or corridors where an alarm needs to be given but where
a Smoke Alarm would be prone to nuisance alarms or excessive
contamination.
The Remote Siren Ei167RC must only be connected to the follow-
ing Ei Smoke Alarm and/or Heat Alarms: Ei141/144/146/151/154
/156/161RC/164RC/166RC. A maximum of 12 Units including the
Remote Siren can be interconnected. Do not connect to any other
type of Ei Smoke Alarm or to any other model produced by
another manufacturer. Doing this may damage the units and could
result in a shock or fire hazard.
The installation of an Ei167RC Remote Siren is exactly the same
as that for an Ei161RC Smoke Alarm (see details in the enclosed
Ei161RC instruction leaflet). Obviously, as the Ei167RC contains
no smoke sensor it need not be located at ceiling height and the
other siting restrictions applicable to the smoke sensor in the
Ei161RC Smoke Alarm need not be followed.
After installation and regularly thereafter check:
(1) The green power light is on showing the AC mains is
connected.
(2) Press the test button on the remote siren - the siren should
sound within 10 seconds and also the Smoke Alarm(s)
interconnected to it should sound. The red LED should flash once
a second.
(3) Press the test button on an interconnected Smoke Alarm - the
Remote Siren should sound within 10 seconds.
Your Remote Alarm should be checked regularly as above when
you are checking your Smoke Alarm.
The rechargeable battery in the Remote Alarm should be checked
in the same way as for the Ei161RC Smoke Alarm.
AICO LTD
Oswestry,
Shropshire SY10 8NN,
United Kingdom.
www.aico.co.uk
Ei Electronics
Shannon,
Co.Clare,
Ireland.
www.eielectronics.com
Checking the Remote Siren
230V a.c. REMOTE SIREN
(with built-in rechargeable battery)
Model
Ei167RC
P/N A14443 Rev1
The Remote Siren Ei167RC is designed to be interconnected to
an Ei Smoke or Heat Alarm (230V a.c. only) so that when fire is
sensed the Siren will sound. It is very similar to an Ei161RC
Smoke Alarm except that it contains no smoke sensor so it will not
respond to fire itself but relies on a signal on the interconnect wire
to make it sound. It is ideal for installation in areas such as
kitchens or corridors where an alarm needs to be given but where
a Smoke Alarm would be prone to nuisance alarms or excessive
contamination.
The Remote Siren Ei167RC must only be connected to the follow-
ing Ei Smoke Alarm and/or Heat Alarms: Ei141/144/146/151/154
/156/161RC/164RC/166RC. A maximum of 12 Units including the
Remote Siren can be interconnected. Do not connect to any other
type of Ei Smoke Alarm or to any other model produced by
another manufacturer. Doing this may damage the units and could
result in a shock or fire hazard.
The installation of an Ei167RC Remote Siren is exactly the same
as that for an Ei161RC Smoke Alarm (see details in the enclosed
Ei161RC instruction leaflet). Obviously, as the Ei167RC contains
no smoke sensor it need not be located at ceiling height and the
other siting restrictions applicable to the smoke sensor in the
Ei161RC Smoke Alarm need not be followed.
After installation and regularly thereafter check:
(1) The green power light is on showing the AC mains is
connected.
(2) Press the test button on the remote siren - the siren should
sound within 10 seconds and also the Smoke Alarm(s)
interconnected to it should sound. The red LED should flash once
a second.
(3) Press the test button on an interconnected Smoke Alarm - the
Remote Siren should sound within 10 seconds.
Your Remote Alarm should be checked regularly as above when
you are checking your Smoke Alarm.
The rechargeable battery in the Remote Alarm should be checked
in the same way as for the Ei161RC Smoke Alarm.
AICO LTD
Oswestry,
Shropshire SY10 8NN,
United Kingdom.
www.aico.co.uk
Ei Electronics
Shannon,
Co.Clare,
Ireland.
www.eielectronics.com
Checking the Remote Siren
230V a.c. REMOTE SIREN
(with built-in rechargeable battery)
Model
Ei167RC
P/N A14443 Rev1
-
1
Ei Electronics Ei167RC User manual
- Category
- Smoke detectors
- Type
- User manual
Ei Electronics Ei167RC is a mains-powered, 230V AC remote siren with a built-in rechargeable battery, designed to be interconnected with Ei smoke or heat alarms. It provides a loud alarm when triggered by a connected smoke or heat alarm, alerting you to a fire emergency in areas where a smoke alarm may not be suitable, such as kitchens or corridors.
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Related papers
-
Ei Electronics Ei160RC User manual
-
Ei Electronics Ei168RC User manual
-
-
Ei Electronics Ei129 User manual
-
-
-
Ei Electronics Ei2110 User manual
-
-
Ei Electronics Ei144 Heat User manual
-