PRODUCT SHEET
GB
5019 636 01002
A. Refrigerator compartment
1.
Crisper drawer
2.
Rating plate
3.
Shelves / Shelf area
4.
Thermostat/light unit
5.
Fan with antibacterial filter (depending on the model)
6.
Door trays
7.
Drinks dispenser or door trays (depending on model)
8.
Bottle rack
B. Freezer compartment
9.
Shelves
10.
Area for freezing
11.
Area for storing frozen foods
12.
Ice tray
13.
Freezer compartment door
Important:
•
The number of shelves
and configuration of accessories
may vary, depending on the model. All shelves and door trays
are removable.
•
The appliance accessories are not suitable for
washing in a dishwasher
.
•
The internal temperatures of the appliance
depend on
the ambient temperature, frequency of opening the doors, as
well as location of the appliance Adjust the thermostat knob
depending on these factors.
The anti-bacterial filter
ensures a higher level of hygiene in
the refrigerator through continuous purifying the air of
bacteria. Remove it from the box found in the crisper drawer
(item 1) and insert into the grid (item 5c).
Replace the filter every 6 months.
1.
Remove the filter together with the grille and dispose as a
whole.
2.
Replace the filter and the grille with the new ones.
3.
The replacement procedure is attached with the filter.
Our After-sales Service can supply this type of filter.
Fan (depending on the model)
The fan
helps achieve a better temperature distribution
inside the refrigerator compartment, and optimizes food
storage conditions.
Important:
Do not obstruct the air intake area (5a) with
food.
Fan with a button
Press button (5b) to turn the fan on when the ambient
temperature is above 27 ÷ 28°C, when condensation occurs
on the shelves, and in the instances of high air humidity
Important:
The fan ONLY runs if the compressor is working.
Make sure to turn the fan off in lower ambient
temperatures.
The fridge-freezer is turned on by means of the thermostat
located inside the refrigerator chamber.
The thermostat adjusts temperature in both
compartments.
Fridge/Freezer compartment controls
Thermostat set to
1/MIN
:
low cooling intensity
Thermostat set to
2-3/MED
:
medium cooling.
Thermostat set to
7/MAX
:
maximum refrigeration
intensity.
Thermostat set to
•
:
cooling and lighting off.
Recommended thermostat setting: 2-3/MED position
.
Light
- how to replace the bulb
Before replacing the bulb, remove the power plug from the
mains socket. Immediately afterwards:
- turn anticlockwise (as shown in the figure).
A.
Thermostat knob
B.
Light button
D.
Thermostat setting indicator
E.
Light bulb (
max 15 W
)
